Search results

  1. R

    1985 30 hp johnson ( any good?)

    A 1985 model 35 HP was an excellent motor.-----Parts new and used are everywhere.
  2. R

    1955 Mile Master fuel tank, instructions for changing o-rings and springs in connector?

    I used to push the plunger in.----Pick out the o-ring.----Push in a new o-ring.----Did this regularly 50 years ago.
  3. R

    mercury 9.8 hp .... water flows through but will not pee?

    Replaced plastic washer at the top of water tube ?
  4. R

    mercury 9.8 hp .... water flows through but will not pee?

    Serial # is ??----Is the water level 8" above the impeller?-----What did the old impeller look like?-----Did the motor suffer from severe overheat ?
  5. R

    1977 70HP Johnson Shift Rod

    Best to verify if 21 23/32 is the correct dimension for a 77 model !
  6. R

    Bad Transom?

    Boat bumped in to something.----Or a vehicle bumped into the boat.-----I would consider that to be an easy fix.
  7. R

    1996 40HP Force (by Mercury)

    Your location in Ontario ?----Rainforest might mean for you to shop on Amazon !
  8. R

    Mariner 9 HP compression issues

    Are you mixing gas and oil at 50:1 in the tank ?----Did you install a new water pump impeller ?---A 9.9 HP ??-----Serial number?
  9. R

    1927 Johnson Outboard Boat Motor K-35 SN 53815

    Find-----aomci------Old gray haired guys that know about old motors.
  10. R

    Evinrude 55 HP Running On 1 Cylinder

    See post #2 on this.---It is all simple.
  11. R

    1990 V4 runs on two cylinders at low RPMs

    The float bowls are warped.-----There are aluminum replacements.-------Torque on those 4 screws is about 10 INCH LBS ---or the same as not very much.
  12. R

    I REALLY need input on a (just purchased, no history) OMC TurboJet 115 Initial startup and troubleshooting attempt.

    But the VRO does not put oil to the bearings directly.----The VRO mixed oil with the gasoline before it goes to the carburetors.
  13. R

    1990 Force 120HP #2 Cyl zero compression and upon opening piston shows damage

    Fuel should not leak out the float bowl vent hole.----Need to inspect both carburetors I say.
  14. R

    Mercury 650 70’s outboard

    Just nuts and bolts.
  15. R

    Mercury 650 70’s outboard

    ???-----Poppit valve must open at higher throttle settings.----These 3 cylinder motors have enuff cooling issues already.----Do not ignore a leak there !
  16. R

    Mercury 650 70’s outboard

    Take the covers off.---Inspect parts.------Replace diaphragm and gaskets for the covers.
  17. R

    Mercury 650 70’s outboard

    There is a vent hole in some covers.----It allows the poppit diaphragm to move.----If water leaks out ,the diaphragm has a hole or is not sealed properly.
  18. R

    1987 Johnson 50 to 60

    Is one of those prop rated and the other one crank rated ??
  19. R

    4.5 mercury 2 stroke

    5 HP motors are used on 25" and 3000 LB sailboats to get in and out of the harbor.
  20. R

    Evinrude 50 rundown help

    Mix gas and oil at 50:1 on it.-----Operate bulb on hose till firm.----Raise fast idle lever.----Push key in and hold it in while cranking the motor over.-----Push key in as needed till motor warms a bit.----Do not let motor rev wildly in neutral.----Install a new water pump impeller and test the...
Top