Search results

  1. alldodge

    Crownline 180br 2010 wiring help

    The Tach comes from the - side of the coil to the Tach sense and is Gray The wires in the pic are not from the motor but part of the boat wiring. Most boats don't have diagrams that can be found. Need a voltmeter to see which have power, or if they get power when the key is turned ON. Then...
  2. alldodge

    Purchasing 2nd Boat: Jet or Stern Drive?

    I know both the of the LCS class ships very well. Was the Logistics Manager for the 57MM on the bow for them
  3. alldodge

    Purchasing 2nd Boat: Jet or Stern Drive?

    Would sure like to see that report Not saying PB Mag would stretch the truth about anything, just saying :unsure:
  4. alldodge

    LED Bulb trips breaker

    That's my guy
  5. alldodge

    LED Bulb trips breaker

    No GFCI and its not the LED as I originally thought, just everything I was watching lead me in that direction. After total disconnect it still tripped later. Hope I don't have to just rip the basement ceiling out and run new wires
  6. alldodge

    LED Bulb trips breaker

    Agree, but nothing else is showing anything, so it's still chasing a ghost
  7. alldodge

    Purchasing 2nd Boat: Jet or Stern Drive?

    Don't forget the jet is not as efficient, but does weigh about 500 lbs less then the larson
  8. alldodge

    LED Bulb trips breaker

    Maybe, I've removed all the outlets before looking for problems, checking connections It is weird that it was only tripping when the fan was connected (on or off), then the next time it was something else. Never liked metal boxes because they were always to small IMO. Might just get some...
  9. alldodge

    Can you search DMV records for a particular car

    Golly gee wiz, the officer can find out how many and where (as in county location not actual address) , which can provide location only info
  10. alldodge

    LED Bulb trips breaker

    Been about a day and a half and fan continues to run. Only thing that is different is I wrapped electrical tape around the side screws on the outlets in the metal boxes. They should have had that before and don't know why they didn't. That said there isn't any way the screws would contact the...
  11. alldodge

    2006 Volvo 5.7 osi-d crank no start

    Maybe, if it has the old nylon covered cam gear, otherwise I don't think so
  12. alldodge

    2006 Volvo 5.7 osi-d crank no start

    Two dead cylinders would be an issue with unburned gas out the exhaust, but it isn't the reason it won't start. There is something else going on It just makes it easier, and if I was willing to spend 4K to find out what's wrong, might as well get someone to rebuild with guarantee cost of a...
  13. alldodge

    New prop for my 1996 2052 capri cuddy

    ok, so if your getting at or close to 4800 RPM when the boat is normally loaded (people, fuel, gear) then your good, IMO. If your on the low side then might be something to work with. If your on the high side then once the prop is replaced the RPM will come down anyway What RPM are you...
  14. alldodge

    New prop for my 1996 2052 capri cuddy

    If your getting Close to or at WOT RPM then get yours repaired or same with stainless Didn't say which 3.0 you have so your WOT RPM can be anywhere from 4400 to 4800
  15. alldodge

    Removal / Fitting Duoprop

    Same with B3 and understand your concern
  16. alldodge

    2 bottom bolt loops on y pipe broken

    If there is enough left may still be good
  17. alldodge

    Removal / Fitting Duoprop

    Don't know the dimensions I set my elbow for torque on props, and never had one loosen or come off
  18. alldodge

    2005 Rinker 232 Cuddy...water in Cuddy

    I have same model just 1995 Should be bow up (just slightly is enough) with plug out for storage
Top