Search results

  1. alldodge

    Mercruiser 6.2l 300 (2018 model) Gimbal bearing grease how to?

    Being a 6.2 it was probabley during the change over to permalube bearings. As Tank said, pull the drive every season and check for roughness. Then do the rest of your maintenance
  2. alldodge

    91 four winns 285 winterizing question

    A trick you can use to use less AF is disconnect the 2 lines on the tank and connect them together. This way no AF is needed in the HW tank
  3. alldodge

    Switch for BP800

    ok, appears to be a single pole switch momentary on, off, momentary on https://www.walmart.com/ip/Heavy-Duty-Toggle-Switch-SPDT-Momentary-Center-Off-Both-Sides-20-Amp/662271942
  4. alldodge

    Cracked upper unit housing at spanner nut

    Do some close looking but found this one https://www.ebay.com/p/1922191567
  5. alldodge

    Cracked upper unit housing at spanner nut

    Which upper is it? I'm not seeing the lube bottle port
  6. alldodge

    Switch for BP800

    Look at the switch and see if you can determine the amp rating of the switch. Then look up Exp: 15 amp joystick switch replacement It will come back with things like these https://www.amazon.com/Joystick-Controller-Position-Switch-Replacement/dp/B07TWX6HJK Note the higher the amp rating the...
  7. alldodge

    Cracked upper unit housing at spanner nut

    Its junk, need another
  8. alldodge

    Block sealant...in a raw water system

    90% of all is prep. It must be really, really, really clean for stuff to hold. Suggest remove the stuff, grind it, the wire wheel it real clean. Wipe done with acetone, then mix up JB Weld and put a thin coat on just around the crack. Let it dry and ruff it up some with sand paper. Wipe...
  9. alldodge

    2002 Volvo Penta SX outdrive leak

    Did you check close to 5 psi and rotate the drive and prop shaft? If so, run it next season and pull the drain plug just enough every once in a while to see if something starts to show up
  10. alldodge

    Need Help Installing Distributor in 4.3MPI

    Its like the wizard of OZ, don't pay any attention to the thing behind the curtain
  11. alldodge

    Random knock over 4k RPMs...

    IMO (others do vary widely) one season isn't that big of a deal. As Bondo said, just check the filter Edit: see if its clear and that it smells like gas
  12. alldodge

    ManualsLib Warning

    ManualsLib.com has been a fairly trusted site for some time. Even Norton's list it as safe. Wife tried to download a old manual for a rice cooker and got the old warning pop up. Something along the line of Your computer has been infected by a Trojan virus and need to call Microsoft at a...
  13. alldodge

    Random knock over 4k RPMs...

    The knock sensor picks up on a per-ignition knock, but is actually heard as a ping. If this is an actual knock (some louder) then might be something else. As has been mentioned would be good to check in any case. Could use a serial number, but if its a MPI Might be a distributor cap going bad...
  14. alldodge

    Going to look at the sea doo switch

    Sorry, my bad
  15. alldodge

    Going to look at the sea doo switch

    Translation from Greek If you want to have a garage, you have to rent it, but if you want to have a garage for a car, we can rent a garage in winter and get a new rent
  16. alldodge

    Going to look at the sea doo switch

    We've had them for years and are great for smooth water days. If water gets rough you will be doing a lot of pounding
  17. alldodge

    Buying a automotive engine to replace my mercruiser, need opinions

    454 and 502 is same size block, only difference on the outside is where the holes for brackets might be. Use all the stuff from your 454 on the 502 (starter, ALT, etc). You do want brass or stainless core plugs even with fresh water, otherwise they will rust out. Also use a marine circulating...
  18. alldodge

    Carpet question 1990 Searay 180BR

    Suggest go to local carpet store and ask them
  19. alldodge

    Vessel View installation

    Need to have a 555 ECM Is your serial number 0M3000000 or higher?
  20. alldodge

    Beeping

    With it happening as speed increases I would think its the Temp switch. As speed increases, temp also increases slightly and may be just enough to make it happen. Disconnect the switch (not the gauge) and see if it stops Don't think its the oil pressure because of an increase in pressure...
View older results
Top