Search results

  1. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Looks like the screws were sealed with something like silicone, and if so it most likely are leaking. Can take a philips screw driver and on the inside of the transom, down low where the screws where removed, try to push it into the transom. If it moves its soft
  2. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Water logged, now comes the expensive part. Put a piece of tape on maybe 1/4 drill bit, have it about 1/2 inch from tip and drill some test holes inside. Do transom, stringers and other areas down low.
  3. alldodge

    Old ford 302 no spark

    Resistance equals heat, heat equals a bad connection. No way a test light will show full voltage
  4. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Dont get why folks want to spend money except trying to find out the issue
  5. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Weight the boat and trailer just to see how heavy you are.
  6. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Your water logged and that's what's causing the issue. Need to find where the water is, transom and/or hull
  7. alldodge

    Old ford 302 no spark

    I'm seeing corrosion, maybe remove the wires off the stud and clean them up shinny
  8. alldodge

    350 Mag MPI intermittent rough running.

    Good to hear Note, trolling does a lot of loading and unloading of the prop. Make sure you keep the coupler greased so it won't strip it out
  9. alldodge

    You might be out of shape, But Then Again

    Thanks Scott, not ready to leave yet
  10. alldodge

    Old ford 302 no spark

    Ya got something miss-wired Here is the Ford wiring I have. Note the dash wire is a resistor wire coming from the purple and choke
  11. alldodge

    You might be out of shape, But Then Again

    Thanks Ted, me to, don't want to go under the knife but also don't want to have to stop doing work
  12. alldodge

    You might be out of shape, But Then Again

    For the last few years when I get doing some repetitive or prolong hard work I get to breathing heavy. The difference is I have to stop, lay on the ground and try and catch my breath, and sometimes pain in the chest. As time went along it took less time for me to be in the same position...
  13. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    With the upper one being under water the boat has to have taken on water. Take it to a CAT truck scale and weight it. If you haven't done it before, go inside first and tell them what you want to do. Pull the boat in and disconnect it from the truck, making sure the boat sits completely on...
  14. alldodge

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Never heard of cobalt doing something that off of spec, so wonder if the hull is water logged
  15. alldodge

    Old ford 302 no spark

    Ok then its working There should be 2 wires on the Pos side of the coil. One supplys full 12V when cranking and the other supplys about 9V once its running. What you just checked was the 9V connection. Place the meter on the Pos side of coil and see if you get full 12V when cranking. Can...
  16. alldodge

    Mercruiser 7.4L Bluewater inboard winterization

    Doing ok, just getting g ready for T day Closed cooling is easier then open so u should have no issue next year
  17. alldodge

    Old ford 302 no spark

    When it opens/closes is there a spark between the points opening?
  18. alldodge

    Mercruiser MAG 350 MPI 2005 -No compression on one cylinder

    There is water drops on the piston and the rust all indicate a blown head gasket. Not to mention the 190 psi means water in those cylinders
  19. alldodge

    Old ford 302 no spark

    Check for power at Pos side of coil. If its there, with points open see if ther is power on the Neg side of coil. If both are yes, loosen dizzy and rotate to see if points open and close as the dizzy is turned
  20. alldodge

    2004 50hp won’t start or trim/tilt

    Pull the engine connector apart and clean the contacts. Use a voltmeter and trace voltages from the battery to the key and at the motor
Top