Search results

  1. alldodge

    For those that have tried signature four by 4 props???

    The B3 4/3 is Mercs XR series and will be different then going from a 3/3 to Hill marine 4/4. I went from 26P 3/3 to 24P 4/4 and did better because the 26P I could not reach 5200 rpm. The hole shot was better as well. If you buy direct thru Hill Marine they will exchange the props as many...
  2. alldodge

    wiring diagram

    All good, but no need to have Bats loose, they can be secured, and should be in either location
  3. alldodge

    MerCruiser 8.2 big block 2014 — shuts off after 5-7 min of running

    Thanks, were on same page Need a motor serial number and if the boat has digital controls or cable When it won't crank, check the 50 amp breaker on the motor. It should have 12V on both sides. If it has it only on one side then the breaker is disconnecting. The breaker will reset when it...
  4. alldodge

    454 knocking noise and water in oil after sitting for 4 years

    Never heard one that sounded like that, that didn't have some major problems. Pull the drive and see if it quiets down. If it doesn't can start with exhaust and work your way into the motor. Need to get the water out before it starts rusting
  5. alldodge

    Ran out or gas, and Gas can

    ^^^ that is my plan
  6. alldodge

    454 knocking noise and water in oil after sitting for 4 years

    Being water in the oil its rebuild or replace. In any case its time to pull the motor
  7. alldodge

    MerCruiser 8.2 big block 2014 — shuts off after 5-7 min of running

    Clarify your term. For me it means the motor will not crank, so not turning over. Others use the term it cranks but will not start? If it does crank but not start. Do you get 2 beeps when the key is turned ON (run) before it cranks?
  8. alldodge

    new surge brakes installed

    Need to see what your seeing
  9. alldodge

    Ran out or gas, and Gas can

    pics
  10. alldodge

    Ran out or gas, and Gas can

    Fixed my can. As joe mentioned the threads are different so was going to just cut the thing off and use a piece of hose on the end with clamp. Figured how to take the thing apart and it should work ok but better. Basically removed the plunger and spring. Plunger has 2 o-rings, 1 small on top...
  11. alldodge

    wiring diagram

    Don't know how its wired, if it has a 12 or 24V trolling, but to know how to wire it up. :unsure: thats a tuff one This will work if its a 12v troller and an ACR Look at the house Bat as 2 in parallel
  12. alldodge

    LED Driver question

    I'm not taking the light apart to see how its wired. It has voltage and amperage previously listed. I can go to Ottlite and get the same led driver (with part number), but want one which might be made better and last longer. Assuming I do need a 300mA led driver and not a power supply
  13. alldodge

    2006 Sylvan 1800 expedition sport

    Guessing, between center rod storage and the stern, under the deck
  14. alldodge

    wiring diagram

    The suzuki df 115 has a 40 amp Alternator, so that's not bad. The setup may already be wired which allows the motor to charge all Bats, and the onboard charger to do as well. Would need to see how its wired to determine Moving trolling Bats to the rear will require larger cables do to voltage...
  15. alldodge

    LED Driver question

    My bad 300mA
  16. alldodge

    Replace chain on floating dock - recommendations?

    I would normally go galvanized but... The chain that is there now, how long did it last? Not to side track, and taking docks in will make then last longer, but what about full float using pipes? My marina holds a few hundred boats using pipes (depths vary zero to 20 or so feet). About a 4 ft...
  17. alldodge

    wiring diagram

    More info first What motor? Is this a 12 or 24V trolling motor? Do you want to charge Bats using the motors alternator and/or built in charger?
  18. alldodge

    Engine Re-power

    4 strokes weigh more then 2 strokes Example : A Seadoo 2 stroke 130hp top speed is same as 4 stroke 155hp
  19. alldodge

    new surge brakes installed

    Yes master first, then wheel cylinder furthest from the master
Top