Search results

  1. alldodge

    86 3.0

    It is a fuse, it's inside the square block and the fuse 2nd pic is inside the block
  2. alldodge

    Mercruiser Serial Lookup 0M336203

    Check my link again if shows manual number
  3. alldodge

    Mercruiser Serial Lookup 0M336203

    Seloc .... SELOC .... he said SELOC :poop: :poop: You want a Merc manual At any rate its after 1998 Hey @achris or @Fun Times can you advise further Also looks like the manual cost a whopping $28 https://www.mercruiserparts.com/bam/subassembly/30905/4893/0
  4. alldodge

    Mercury 2 cycle alarm

    Might be the float switch went bad, or is hanging Disconnect the tank switch wires to see if the alarm stops, if it does your probably good
  5. alldodge

    Kill problem

    Not sure, reminds me like the key is turned off
  6. alldodge

    Mercruiser 3.0 rough idle at start and stumbles momentarily during acceleration

    Most likely it needs the carb rebuilt, but there is also a issue with the electrical system. Watch the fuel gauge it pegs full then drops to empty and then back up. Might be a bad ground Clean both ends of all battery cables including the grounds (both ends)
  7. alldodge

    3.0l Thermostat questions

    The sleeve does come out and sounds like its welded it self in there. Part doesn't cost that much, but need your serial number to verify
  8. alldodge

    86 3.0

    The 90 amp fuse is between the alternator and battery I would use 2 AWG Don't use CCA wire even in fresh water. Get some automotive battery cable wire at the least. Its not silver plated but seal the ends and they should last for some time before needing to be cleaned
  9. alldodge

    Waste tank cover removal

    I meant 4000 Do agree try to get as much as you can off, maybe it will break free
  10. alldodge

    Bennett Trim Repair And Auto Pro Install

    Tabs are intuitive to use, you'll figure it out easy. Mostly about leveling the boat while cruising.
  11. alldodge

    Waste tank cover removal

    Yes, even if its 4200 it will probably be destroyed getting it off. Is the sealant hard or soft?
  12. alldodge

    2009 4.3 mpi running hot

    Being raw water cooled the motor should have 140* thermostat. The 160* can cause the salt to deposit inside the motor. Can also have Bravoits issue. Put a piece of clear hose at the thermostat housing hose which comes from the raw water pump, to check for air bubbles
  13. alldodge

    Pressure testing fuel tank

    Glad your ok, you could have been hurt or worst. Take the surface area in square inches then multiply that by the pressure in the tank.
  14. alldodge

    Waste tank cover removal

    Agree, looks like 5200 and if so, will need to chisel it off Mine had a problem, but cleaning it didn't fix the issue, had to replace
  15. alldodge

    How to access anti siphon valve

    Don't know your particular boat but its a USCG requirement to have access to those fittings. Wonder if there is something under the carpet? If it's not there I guess its cutting time
  16. alldodge

    Bennett Trim Repair And Auto Pro Install

    I can leave the auto part off, and most the time I do. The issue with the last one was the auto was off but when I used the tabs it turned the pump on and wouldn't shut off
  17. alldodge

    Tach settings cobra 3.0

    Its how many pulses come from the coil per revolution. A 4 stroke 4 cylinder produces 2 pulses per revolution, I would think it would be 2
  18. alldodge

    Bennett Trim Repair And Auto Pro Install

    Installed another, waited to calibrate until Bennett was on the phone. Did that and its working like all the others except the last one. Its not hanging but still trims to much. He is going to talk the the engineer again to see what they say Sure wish I never heard of autotrim
  19. alldodge

    350 mag mpi 2000 won't start

    Just noticed a forgot the pic
  20. alldodge

    Top Speed Issues

    Suggest trying to use the return key more, this is real hard to read Using that much fuel, your plugs should be wet and fouled
Top