Search results

  1. alldodge

    Low power under heavy load

    Has Merc carb https://www.mercruiserparts.com/bam/subassembly/30910/2330/70
  2. alldodge

    I feel like an idiot for having to ask this question, but never seen this before....

    Running out of fuel could still be the ASV if slowing down helps brings it back
  3. alldodge

    I feel like an idiot for having to ask this question, but never seen this before....

    I understand your dilemma, have not seen this my self. As in my pic this is the way I see it. Could remove the sender and look inside to see which is which. Other then that can apply some air to the ports to see if the exit on top or below
  4. alldodge

    I feel like an idiot for having to ask this question, but never seen this before....

    Pic please?
  5. alldodge

    Minor Surging After Carb Rebuild - TKS 4.3 '06

    If compression is low, then that would explain why it doesn't do well in the water.
  6. alldodge

    Low power under heavy load

    Motor
  7. alldodge

    Alpha 1 gen 2 information

    Things are not adding up with the prop calculator. https://bblades.com/propeller-slip-calculator/ I would suggest getting a SEI 1.62 drive https://www.wholesalemarine.com/sterndrive-engineering-replacement-drive-old-style-r-mr-alpha-one/
  8. alldodge

    Low power under heavy load

    Being the old ones there not bad, tad rich but ok Have you run the boat enough to burn up most of the old gas.? Old gas doesn't get better with snake oil (sea foam or other), just need to remove or burn enough to get rid of it.
  9. alldodge

    Minor Surging After Carb Rebuild - TKS 4.3 '06

    I'm thinking need to get back into the carb for adjustments What are the compression numbers?
  10. alldodge

    Low power under heavy load

    Would need a serial number to verify but being a 01 I would guess it has a TKS carb. Your issue soulnds like it needs a carb rebuild What do the plugs look like?
  11. alldodge

    350 mag mpi 2000 won't start

    Unsure but could be a MEFI-1 or 2, in any case trouble shooting will be the same. Is there 12V at the coil with key ON? When cranking can you see the Tachometer show at least 300 rpm? Need a 12V resistor LED or a digital multimeter with a tone check. Connect the LED or meter as shown and a...
  12. alldodge

    Replace water inlet hose on Bravo 3

    ok, look for "shields marine 1 1/4 intake hose" intake/exhaust hose
  13. alldodge

    Replace water inlet hose on Bravo 3

    Your PN is bulk hose I used 8M0090859 to replace mine https://forums.iboats.com/threads/bravo-itis-fix.680176/
  14. alldodge

    350 mag mpi 2000 won't start

    Kill switch, fuel pump, IAC, ECM, blown fuse Check for 12V at the coil Do you here the 2 beeps and the fuel pump turn ON when key is turned to ON? What is your serial number?
  15. alldodge

    Manufacturer letters pealing off

    New boat, why not take it to the dealer to fix?
  16. alldodge

    Velvo penta does on water

    If your compression gauge is accurate then motor is good enough to run even with the one low cylinder. I'm out of ideas
  17. alldodge

    Bad gas

    Sounding like the pump is bad Could hot wire the pump so it will run for a bit to see if it will pump up
  18. alldodge

    Bad gas

    Take a gas can and put the fuel line going to the filter in it. See if it will bring up the fuel to start the motor
  19. alldodge

    Need help with sterndrive parts

    Did you look down inside the exhaust tube to see if its clear? Every year its best to pull the drive, check gimbal bearing and also alignment. Bearing is checked by putting you fingers in the bearing and turning. It should feel smooth as silk. Alignment needs and alignment bar to check
  20. alldodge

    120 Mercruiser 2.5L - No spark

    There is no base timing mode or shut for your distributor. Just point a shoot to set timing
Top