Search results

  1. alldodge

    Mercruiser 5.0 MPI Bravo 3 overheat 5 minutes after starting it up.

    The check balls
  2. alldodge

    Shift plate

    I'll work up some pic a bit later. Not in the right spot to do it now
  3. alldodge

    Carb or worse?

    The vid/sound is not available for me to see/hear Being a 98 it could have a Rochester 2GC or maybe even a TKS carb Do you have electric or manual fuel pump?
  4. alldodge

    2006 Q4: Strange dash light and won’t start

    That's good, I've been cutting grass Info for future. The red from the starter goes to the 50 amp breaker on the motor Other side of 50 amp breaker wire changes to red/purple Red/purple goes to 10 pin engine plug Other side 10 pin plug red/purple goes to 20amp fuse other side of fuse goes to...
  5. alldodge

    2006 Q4: Strange dash light and won’t start

    It has an ignition fuse, just need to find it. Start with the red/purple wire at the key and trace it back
  6. alldodge

    2006 Q4: Strange dash light and won’t start

    Look for a 15 or 20 amp fuse/breaker on the red/purple wire feeding the key switch. It will either be in the fuse box or can be a inline fuse on the red/purple wire
  7. alldodge

    Shift plate

    The shift plate can be mounted anywhere, its doesn't have to be on the motor. Only limitation is the cable length and bend radius What do you mean by aligning?
  8. alldodge

    2006 Q4: Strange dash light and won’t start

    BTW what motor is in the boat?
  9. alldodge

    2006 Q4: Strange dash light and won’t start

    If the key is turned ON, do the gauges turn ON?
  10. alldodge

    Rebuilt Mercruiser 140/3.0 doesn’t have enough power to plane

    Take the valve cover off, remove No 1 spark plug. Remove + side wire from coil. Bump the starter and watch the rocker arms. Watch for No. 1 cylinder intake valve to open. Keep going slowly and watch to the intake to close. Once closed keep going until the notch on the vibration damper comes...
  11. alldodge

    Bravo 3 delay into forward?

    Yes, don't even need to remove. Loosen enough to see if you get anything other then clean lube
  12. alldodge

    2006 Q4: Strange dash light and won’t start

    Won't start and new light. Don't know what the light is for, but if you can crank the motor but it won't start, check your kill switch (Man Overboard)
  13. alldodge

    Where to start? Mercruiser Overheat / Thanks

    When overheat starts, you always start with the impeller. Does "dealer required" mean you have a receipt that the dealer did replace the impeller? Get a 1 ft piece of clear hose, a hose clamp and male barbed fitting from the hardware store. Disconnect the hose coming from the drive at the...
  14. alldodge

    Mercruiser 5.0 MPI Bravo 3 overheat 5 minutes after starting it up.

    With a distribution valve you have the 3 point. There are also check balls at the bottom of each exhaust manifold. If they stick open, then water is reduced going to the motor. Get a IR temp gun and take readings at different places to see where things are hot
  15. alldodge

    Mercruiser 5.0 MPI Bravo 3 overheat 5 minutes after starting it up.

    Do you have the 3 or 7 point drain system? Have you looked at the check valve?
  16. alldodge

    Delco est woes.

    ok Merc reman and want to time it as a VP. I have the same VP doc and also don't know of a EST module which will provide 20* of advance, most are in the 10* to 12* To time the EST it gets 12V connected which puts it in base timing mode. The 12V shall not be connected to it with the motor OFF...
  17. alldodge

    Priming my 3.0 liter

    ^^Agree, no primer bulbs on IB or IO Change to electric fuel pump Similar issue happens with my 7.4 (mechanical pump) but it doesn't take a lot of cranking. After two 20 second cranks it fires. If your pump is weak, or the antisiphon valve is creating more of a restriction, could take longer
  18. alldodge

    Carb or worse?

    What motor, serial numbers are best? Probably a 3.0 Cap is probably the same.
  19. alldodge

    Delco est woes.

    Your in the Merc section, talking about a Merc 5.7 but show page out of VP
  20. alldodge

    Engine alignment

    Doesn't matter if they are equal or not, its going in/out easy so its where it should be, even your marks look equal
Top