Search results

  1. alldodge

    1981 MerCruiser Outdrive Water Pump

    Its just the body, other parts are in post 2 link I'm not an expert on the 888. Have a look at this thread which has some info. They talk about Sierra 18-3317 https://forums.iboats.com/threads/merc-1-drive-888-188hp-water-pump-kit.478329/
  2. alldodge

    1981 MerCruiser Outdrive Water Pump

    Being a 8 or 9 would put yours in the high S/N range so this should be 46-96148T1 Search only line the number and may find it for less https://www.mercruiserparts.com/96148t1-body-assy-wp Its item 30, I previously said 14 above and changed it
  3. alldodge

    Quicksilver control.

    This all depends on which control you have. Can look thru this link to find the one you have https://www.mercruiserparts.com/remote-controls-and-components Most panel mounts requires to move handle forward in throttle only then the center button can be removed and gain access to the screw...
  4. alldodge

    Guage replacements

    Mostly the diameter of the gauges. Measure the holes and then find gauges that fit. These are most common 2-1/16" - Standard Size Guages. Water Temp, Volts, Oil Pressure, etc... 2-5/8" - Monster Size Guages. Water Temp, Volts, Oil Pressure, etc... 3-3/8" - Standard Size Tachometer or...
  5. alldodge

    1981 MerCruiser Outdrive Water Pump

    Its listing 2 pump body assemblies, below S/N 3784374 and above that number (item 30 The rest of the parts are the same, maybe @Bt Doctur or @Bondo can advise https://www.mercruiserparts.com/bam/subassembly/30852/1579/6
  6. alldodge

    Outboard oil in Alpha one drive

    I wouldn't, list for under 75 HP. Drive cost a bunch more then lube
  7. alldodge

    Pumping out my head issue - vent??

    I would say its the vent. Mine has always been one person Check the charcoal canister in the vent line, or the vent for things like mud dobbers
  8. alldodge

    Help with charging system?

    All good so long as the wire doesn't short out
  9. alldodge

    496 Mag HO RPM issue

    No issue, just letting others know where others have replied. For others in short and the key I had not noticed was My apologies for not taking more time when I first read the problem. This has to be an issue with the DTS calibration or a component in the controls
  10. alldodge

    Not enough brain cells

  11. alldodge

    At full throttle and it died...

    A fuse blew or breaker tripped. Check the ignition fuse (will be 15 or 20 amp). May be inline behind the helm or on a panel. Put a voltmeter on the Red/Purple wire on the key switch to see if 12V is there If its not there, check the 90 amp fuse on the starter post with meter
  12. alldodge

    Mercruiser 5.0 TBI

    What is your motor serial number?
  13. alldodge

    496 Mag HO RPM issue

    Welcome, OSO https://www.offshoreonly.com/forums/general-q/371779-496-mag-ho-rpm-issue.html#post4791501
  14. alldodge

    Non skid floor help

    In the USCG we would put down a thick layer of paint and then sprinkle or pour sand over it. Once dry, sweep or hose excess off, looks good
  15. alldodge

    2008 Mercruiser 3.0 Drive Lube

    The HP gear lube would be a good choice New to you boat, suggest doing all the maintenance so you know where you stand for the future. There is a lot of info in the Stickies at the top of this section Change the impeller and inspect bellows. Check engine alignment Change oil, oil filter, gas...
  16. alldodge

    2008 Mercruiser 3.0 Drive Lube

    Yes, same lube as in the leg. Its filled from bottom to the top, same as OB. Then the lube bottle is topped off to the fill line. After the first few hours of use after changing lube, the lube in the bottle will lower. This is normal as the air in the top of the drive is bleeding out. If...
  17. alldodge

    Help Aq271 no spark

    That one is no longer made. Has been replaced by a few others like Sierra 18-5239 Autolite makes one also Pertronix Most likely that module has gone out, and needs replacing
  18. alldodge

    Engine Dies When Hot

    Anything is possible, just not very likely The below is what happens when a key switch goes bad or wire on RUN side is loose No 12V when key is ON to the coil Have 12V when key is cranking to the coil
  19. alldodge

    Help Aq271 no spark

    The prestolite distributor is just a points type. The points need to open and close as the rotor turns. If they are not doing that then adjust so they do. Make sure the coil has 12V while cranking. Once it starts it would have about 9V If they are operating correctly, then may need the...
  20. alldodge

    2000 Four Winns H170 with Volvo 3.0 - Engine removal necessary?

    The stuttering would indicate it needs a carb rebuild The noise does sound like the starter. Being a 3.0 there should be room to get at the bolts. The issue may be the design of the boat. Are there any panels/seats which can be unbolted? If not then its the boat that causes the problem...
Top