Search results

  1. alldodge

    VP 5.7 oil reading high

    Measure the tube and then compare how far the stick will go in. Oil will be same level in tube as in the pan
  2. alldodge

    Constant Engine alarm

    My first pic showed J1-6 but that point to the wrong wire, its J1-8 for that one and this one. Pic below is of the GXI-D and I'm pretty sure it should be the same for the E. While the depth finder does have an alarm, you have to tell us if its the motor or depth alarm As prior, the ECM is the...
  3. alldodge

    Constant Engine alarm

    Depending on which GXI the Tan/Blue wire connects to the ECM and then motor alarm. If the Tan/Blue wire is chaffed and is grounding out anywhere between J1-6 and the alarm at the helm, the alarm will sound. The alarm is connected to 12V when key is turned ON, and the other side is connected to...
  4. alldodge

    2003 Volvo Penta 3.0 GSP max speed 25mph

    Timing shunt Having a VP there is no shift interrupter, but the 2 wires are connected together and the one is connected to a 12V source Timing advance means it goes more toward Before TDC not After
  5. alldodge

    How to wire ignition coil Volvo Penta AQ200D

    No expert on VP but found the 5.0 nd 5.8 FL wiring with points
  6. alldodge

    Power steering help?

    Those old ones need to be balanced, see page 6A-7 in manual 6, but its not at boatinfo
  7. alldodge

    Wiring color codes for a 2004 Sea Ray 185 Sport ?

    It should be these
  8. alldodge

    1999 4.3 mercruiser spark, oil pressure, no fuel?

    This is in the OB section and should be in the Merc section GA_Boater There should be a Purple/Yellow stripe wire coming from the outboard small post on the starter. This is the wire which feeds the pump while the motor is cranking. Once it starts, power is removed from the Red/yellow until...
  9. alldodge

    Lose power to everything except trim switch on 2004 caravell 187bw mercruiser 4.3

    If your not getting power thru the fuse its blown. The fuse is replaceable https://www.ebay.com/itm/Bussmann-CBBF90-CBBF-Battery-Fuse-/164317075140 Remove the fuse and have a look Most have all the wires attached to the fuse, when actually only need the orange wire. The fuse is used to...
  10. alldodge

    Engine install and align. what am I doing so wrong??

    Is the bar made to spec?
  11. alldodge

    Mercruiser alarm only at idle

    Thank, Carb motor The switch and sender are both port side low where the remote oil filter is connected. The sender is item 8 and the switch is item 10. Look at your part number listed to see if it was the sender or switch Sender 8M0068784 Switch 8M0070108 Not having a ECM but do have a TB5...
  12. alldodge

    Kill switch

    Yes, you on the right path
  13. alldodge

    Engine install and align. what am I doing so wrong??

    The bearing doesn't look good but that's a different issue maybe This is how it should go together The mount either uses a spring washer OR the fiber washer, not both. All depends on what transom assembly is being used
  14. alldodge

    2002 3.0 Electronic Timing Help Needed

    The timing advances by moving more Before TDC Wires on shunt and shift interrupter are connected and disconnected with the motor running. Don't know your serial number but timing of the 3.0 can be anywhere from 1* BTDC to 2* ATDC Serial number break: 0L096999 and below - 1 BTDC Serial number...
  15. alldodge

    Squeal when boat first starts

    Taking the battery cable off the battery may have just blown the regulator in the alternator. The old remove the battery cable on cars use to work, but even now it can blow the reg in the ALT Agree its the ALT, but the belt is not tight enough or the belt is not the right size. Looking at the...
  16. alldodge

    Mercruiser Bravo ONE lower shift cable replacement

    Do not drill it out The outer jacket is removed and installed from the drive side There are 2 different cables used and depends on which year you have. In the link below is the manual and how to replace the cable http://boatinfo.no/lib/mercruiser/manuals/mercruiser11.html#/316 Folks make a...
  17. alldodge

    Running cold

    Being a 2011 it should have CAT's (catalytic converters) and have a PCM 09 I'm thinking the poppet valve (item 15) which has had many troubles
  18. alldodge

    1987 OMC King Cobra 5.0 Alternator Issue

    Howdy Something is miss-wired and don't think its at the ALT, maybe at the trim pump or starter. Here is the OMC wiring diagram, and look thru to see if wiring is correct
  19. alldodge

    Chrysler 130

    Started taking the from apart, its taking a lot of heat to get it to budge. One side Then the other Got the hydraulic trim off after mire heat but didn't take a pic Removed the clamps (or what ever their called) from the bottom which holds the center turning shaft. The bottom bolts...
  20. alldodge

    Guardian Mode Alarm Help

    Check the wiring to/from PCM, it might be shorted to ground For your motor, don't run it until impeller has been changed. Your pump is barely working and won't take much for it to stop and then it can be damaged
Top