Search results

  1. alldodge

    Best Black Caulk?

    Suggest do not use any kind of calk, its not needed if the surfaces meet the specs for the transom, your good. If the transom needs flattening, use something to build it up and smooth flat (JB weld, or other). Then just use the gasket and torque to spec But to answer your question, if you...
  2. alldodge

    4.3 mercruiser no spark at operating temp

    Sounds a bit like your loosing power to the module or pickup. Do you have 12V at the coil when it will not start? If the diode shorted you shouldn't be able to turn the motor off. If its open it would take a long time before the TKS module closed off the extra gas, so it would be running rich...
  3. alldodge

    Volvo Penta 2005 5.7 GXi-f 8cy won’t go over 3k rpms on load

    Wgat I'm seeing is a MEFI controller and it might be a 4, and if so you should be able to use the led and paper clip to get the codes. muc can you assist? If it is a MEFI 4 then use a paper clip and led then turn key to ON without starting. Then count flashes
  4. alldodge

    Alternator

    Wiring diagrams
  5. alldodge

    Alternator

    They both "look" like Mando ALTS because both have regulator wires coming out of the top https://www.mercruiserparts.com/bam/...y/30893/963/70
  6. alldodge

    TKS 4.3L Mercarb

    Depending on the outside temp it looks good 70 degrees F = 35-45 ohms 20 degrees F = 55-70 ohms When 12V is applied to the leads and module is cold, it will slowly increase in length (no click). Here is the bench test
  7. alldodge

    What would cause sudden loss of power?

    Yes, the filter causes a high flow restriction, it does fine a low rpms, but higher and under load it needs much more fuel. It also depends on which filter your have, the old stone filters go in the other way
  8. alldodge

    94 mercruiser 350 low idle after thermostat change

    You need to do some testing first. Measure fuel pressure 30 psi Check for codes using a led and paper clip. With key ON and not running count flashes. The paper clip is also used to set motor in base timing mode for adjusting timing
  9. alldodge

    Site is hosed again

    Thing is all messed up, started last night, so stopped doing anything until this AM. MS Edge or Firefox on two different computers is the same mess undefined
  10. alldodge

    88 OMC 3.0L Coil issue??

    There are thousands of coil replaced every year and only maybe one or two are actually bad. Need to make up a Tee fitting between pump and carb. Can be attached at the carb to the end of the fuel line, or temp replace the whole fuel line with gas line and fittings for a connection. Use a...
  11. alldodge

    94 mercruiser 350 low idle after thermostat change

    Need a serial number to verify, you may have a MEFI 1 ECM and TBI. Could have 1 to 2 issues, fuel pressure could be down, and/or IAC might be an issue. https://www.mercruiserparts.com/350-mag-efi-ski-tbi-gm-350-v-8-1994-1-1 I would start with measuring fuel pressure. To measure pressure you'll...
  12. alldodge

    Mercruiser 4.3 2005 oil dipstick length S/N and service manual question

    You should use manual number 25, and your motor holds 4.5 quarts counting the filter, so your 1/2 quart over. Your motor can have one of 2 tubes and dipsticks, and depends on if it has open or closed cooling https://www.mercruiserparts.com/bam/subassembly/31492/11812/140
  13. alldodge

    primer solenoid wiring

    Primer solenoid should have one wire going to ground and the other going to the key switch. When the key is pushed IN, this turns power on to the solenoid and energizes. If the wire is hot all the time its miss wired or something is shorting to the hot
  14. alldodge

    4.3l 2 barrel won't stay running after new starter

    Purple on top of the starter connections don't add up, and the purple/yellow is on the left BTW, what year is the 4.3?
  15. alldodge

    5.7 timing

    How to test knock sensor on TBV
  16. alldodge

    Mercruiser 4.5 overheating

    No matter what it has reduced water flow to the starboard manifold. Only thing I can see with 4 hoses is with the open cooled system and its for draining during winterization. Where is the rear poppet valve you mentioned? My thought is the check valve on the SB side got stuck and now its free...
  17. alldodge

    Oil Pressure Sensor (OPS)

    According to the manual the oil pressure switch and sender ar connected at location "C" A Tee is used to connect both to the same port. Suggest as Bondo mentioned, get an "easy out" and use that to remove. Be real easy doing so and if it feels like the easy out will snap off, need to stop. The...
  18. alldodge

    Mystery stalling issue on 7.4 mercruiser

    The red/purple wire comes thru at pin 6 and it should be there even when connector is disconnected. If not there, then there is corrosion somewhere, and can also be inside the main connector
  19. alldodge

    Rewiring

    If your wanting a diagram
  20. alldodge

    3 Bank charger w/24v system

    Don't check amps, check voltage. Red to Positive postl and Black to Negative post
Top