Search results

  1. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    If that is a 2.5 , the tell tales do not fully flow until the thermostat opens. I believe those have 140 degree thermostat so yes toasty water comes out. Not all Motors plumb the tell tales that way. That is kind of a Unique feature to some Mercury 2 strks.
  2. flyingscott

    25hp Evinrude

    That is a false reading, they came factory with around 130psi. Let it sit overnite and re-do the compression test.
  3. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    So if it is the newer 2.5 litre your tell tales will be warm/hot as they are connected to the Thermostats.
  4. flyingscott

    Yamaha 703 control adjustment advice

    Did you reverse the cables?
  5. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    Was the old impeller in 1 piece? did you check the sensor itself? Do you know if that is a 2.5 litre? If not somebody here might know.
  6. flyingscott

    Unable to pull stater rope

    How do you know where the bearing is bad? A bad pinion bearing will cause the problems you are having. If you remove the lower unit and the hard spot stays , you will know the problem is in the powerhead. Either way something in that motor/lower unit needs to come apart.
  7. flyingscott

    Unable to pull stater rope

    You realize you don't need to hit anything for a lower unit to go bad right? Many a bearing goes bad without hitting anything.
  8. flyingscott

    GLSTA 115 Low rpm idle

    You adjust the idle by adjusting the low speed timing.
  9. flyingscott

    fuel leaking from weep hole

    You need a new primer diaphragm. Wouldn't hurt to rebuild the whole carb.
  10. flyingscott

    Tell tale or bubbler what’s normal w/o a thermostat

    The water out of the holes will warm. It takes a wide open run with the correct thermostat to get above warm. Especially in cold water. How do you know the thermostat is not installed?
  11. flyingscott

    94’ 15hp

    What do the splines on the propshaft look like? What do you mean new Hub?
  12. flyingscott

    Unable to pull stater rope

    Pull the lower unit
  13. flyingscott

    Spark or No Spark?

    do the rest of the tests.
  14. flyingscott

    How to test VRO system

    how many wires on the VRO pump?
  15. flyingscott

    Spark or No Spark?

    Check your shift interrupter switch. You need to do a dva test and test the stator. should easily jump a 7/16" gap
  16. flyingscott

    Evinrude 9.9 carb question

    2 different carb covers for those motors, 1 is cheap and 1is not. And I do not believe the needles are interchangeable. There is also an update kit that comes with both needles. The kit is pricey 0433973
  17. flyingscott

    1999 90HP Merury 2 stroke outboard winterization

    Change lower unit oil. Fog motor while running it out of fuel.
  18. flyingscott

    Reed vavles

    Check your float level first
  19. flyingscott

    Evinrude 25hp outboard wants to die when I give it gas

    Good way to break the ears off the carb.
  20. flyingscott

    Gun ownership and permits.

    How so? The OPs whole post is about the rules he has to follow to own a gun.
View older results
Top