Search results

  1. flyingscott

    18hp Evinrude

    1972 Evinrude 18 hp
  2. flyingscott

    Clinton hp engine

    Use tcw 3 2 strk marine oil
  3. flyingscott

    1991 Johnson 60 HP not getting spark?

    Get the manual and start testing.
  4. flyingscott

    1985 Evinrude 25 Starter Wiring

    I don't think the OP has a remote model. I did not see the red plug in the pic.
  5. flyingscott

    OMC 115 Turbojet Bad Piston Replacement Help Needed!

    Buy a factory manual for your motor. It will have information and instructions for that model.
  6. flyingscott

    OMC 115 Turbojet Bad Piston Replacement Help Needed!

    Those motors are known for breaking the rings it is very common in the crossflow motors. That motor needs to be bored out and 4 new pistons put in it. Because if 1 breaks the other pistons are not far behind. Pull the motor and do it correctly.
  7. flyingscott

    Clinton hp engine

    16-1 sounds right possibly go to 20-1
  8. flyingscott

    1991 Johnson 60 HP not getting spark?

    Have you done a spark check? Does spark jump 7/16" air gap. The factory manual will tell you how to test all this. A spark tester will cost $10 and looking to see if the lanyard is attached is free. A power pack that may or may not be bad will cost over $100. Your choice.
  9. flyingscott

    1991 Johnson 60 HP not getting spark?

    The control box is where the shifting occurs. Should have a big handle sticking out of it by the steering wheel
  10. flyingscott

    1991 Johnson 60 HP not getting spark?

    Put up a pic of your control box. Anything as new as your motor should have one. Unless it is using an older box.
  11. flyingscott

    1985 Evinrude 25 Starter Wiring

    If you have a push button start here is how your wiring should go. #1 + battery cable to one side of the solenoid on the big terminal. #2 1 wire from push button goes to the + battery cable side of the solenoid #3 Other push button wire goes to 1 of the small terminals on the solenoid #4 other...
  12. flyingscott

    1991 Johnson 60 HP not getting spark?

    Yes got to https://www.outboardbooks.com/ That is a factory manual save your money and do not buy seloc or clymer. One question is the safety lanyard on?
  13. flyingscott

    1985 Evinrude 25 Starter Wiring

    If that is a tiller motor the solenoid is grounded through the neutral safety switch.
  14. flyingscott

    1991 Johnson 60 HP not getting spark?

    Nothing on that strip has anything to do with spark. Have you got a factory manual? Get one if you don't
  15. flyingscott

    1986 Johnson 30 water pump

    Did you put the key in the impeller? Water tube lined up correctly?
  16. flyingscott

    86 Johnson 28 Surging

    What happens if you pump the primer ball? Has the carb been worked on recently? Fuel pump worked on? Put up a pic of the motor and transom. Are you running a shortshaft on a longshaft transom?
  17. flyingscott

    63D orfice high speed jet?

    I agree the jet is not the issue. Can you not message the ebay seller for more info? The size will be stamped on the jet.
  18. flyingscott

    63D orfice high speed jet?

    Ebay has them. seller has 3 left $10.00 simple search to find them. https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=0328544&_sacat=0&LH_TitleDesc=0&_odkw=328544&_osacat=0
  19. flyingscott

    25hp mercury tracker cranks but will not start

    Did you do post #17
  20. flyingscott

    91 Mercury 100 won't run past about 1800 rpm

    Yes if you have the Factory manual you were told to buy
Top