Search results

  1. flyingscott

    Johnson 70 3cyl overheating

    edit
  2. flyingscott

    Johnson 70 3cyl overheating

    So is the motor being limited to around 2800 rpms?
  3. flyingscott

    Fleet Scott 14.1

    Depends on the size of the laminate. The square in the middle measure it.
  4. flyingscott

    2017 Evinrude

    one other thing to ask the owner is the oil setting. That determines which oil to use. If I was buying it I would take it to a dealer and have them set the pump as rich as possible. then run the best oil you can find XD 100
  5. flyingscott

    2017 Evinrude

    there is an oil tank on that motor that will need to be filled periodically. but you should read the manual
  6. flyingscott

    60 HP SCOTT ATWATER DRIVE SHAFT

    ok sorry
  7. flyingscott

    93 Mercury 15 HP vs 92 9.9 Carb?

    Then they may not be the same block the first 9.9 were on a 13 cid block I think or 10. The 15 came out on the 15 cid block. Some work on your part is required.
  8. flyingscott

    Replacement starter coils '58 flying scott 60

    3 sets of points on that motor. Same as used on Mercury and briggs and stratton. Easy to find. Vintage coils are expensive you could try Laings outboards.
  9. flyingscott

    93 Mercury 15 HP vs 92 9.9 Carb?

    You will have to compare the blocks. That was right around the time the 9.9 moved up to the bigger block. If the 9.9 is the smaller block I wouldnt use it without at least changing the high speed jet. Even if it is on the bigger block may still need the jet will have to look up some parts.
  10. flyingscott

    Save or part out?

    They never had electric fuel pumps. They are listed in the service manual but that was around the time McCulloch bought them. I believe they nixed the electric pump. I have an early 58 that still has Scott Atwater on the hood and has a pulse pump like yours. The hood latches break because people...
  11. flyingscott

    93 Mercury 15 HP vs 92 9.9 Carb?

    Look at the middle of the bore and make sure it doesn't narrow in the middle.
  12. flyingscott

    1990 150 HP V6 Leak Down Fail. Help!

    You have to replace the pistons. Do not replace just rings on that motor and you have to do all 6. But pull the heads first.
  13. flyingscott

    1990 150 HP V6 Leak Down Fail. Help!

    If it cant be torqued they are junk. Do what racer said
  14. flyingscott

    1990 150 HP V6 Leak Down Fail. Help!

    How did he do a leak down test on 2 stripped spark plug holes?
  15. flyingscott

    1990 150 HP V6 Leak Down Fail. Help!

    What is the compression? What was done to the motor before starting it after 8 yrs?
  16. flyingscott

    Fleet Scott 14.1

    You might be able to put an OMC coil on the laminate. Are you sure the coil is bad? Those motors had excellent coils and seldom went bad.
  17. flyingscott

    XD50 vs XD100 in mid 90s 3 cyl

    I run xd 100 it is one of the best 2 strk oils out there.. I use it as pre mix n my 92 70 hp.
  18. flyingscott

    2001 Mercury 115 ELPTO excessive oil

    Those motors are impossible to work on without a factory manual. The excessive oil could be a stuck float in a carb or a leaking accelerator pump.
  19. flyingscott

    2001 Mercury 115 ELPTO excessive oil

    You did not get a factory manual it will be specific to your serial #. Call a dealer.
  20. flyingscott

    55ESL69A electric solenoid assembly

    Get rid of the seloc manual and find a Factory manual.
View older results
Top