Search results

  1. R

    1971 Evinrude Fastwin Fuel Gremlin

    Lots of those left the factory with electric start.-----I do not know of an aftermarket kit !
  2. R

    1990 Evinrude 3HP, dies when throttle opened more than half

    They say-----" the bitterness of poor quality is remembered long after the sweetness of low price is forgotten "
  3. R

    need help no start

    Need to confirm the model #---- Not sure if that model # existed in 92-----Unless it is a -----E150GLENC-----?????
  4. R

    Johnson stops dead!

    Your motor does not have ignition coils under the flywheel.-----There is a very reliable charge coil.----And there is a very reliable sensor coil.-----I have never seen those --" all busted up "-----You need to be sure of what your motor has before jumping to conclusions.
  5. R

    Why I do not have new boats.

    You will not have any issues if you can afford new , and throw money at any problems that arrive.
  6. R

    Elgin needle bearings

    ???----aomci-----Would be a good site to look for a new best friend to help you.
  7. R

    Why I do not have new boats.

    New boats are meant to look good in the showroom.-----They and the motors are designed using computers.------There is no step in the computer program that says -----HALT-----lets see if this can be repaired 5 years after commissioning.----Some of the stuff I have seen / heard about is mind...
  8. R

    need help no start

    Look at the model # again.-----Is there a big red plug on the wiring harness ?
  9. R

    1992 15hp Yamaha lower end compatiblity

    Are you sure the 95 model is a 4 stroke ?
  10. R

    1996 Evinrude 48spl warning sound

    The water from the tell tale does not circulate through the engine block.----A 48 SPECIAL would not have left the factory with VRO automatic oil injection.------I would look at the water pump impeller.----Needs a new one about every 5 years.-----Or perhaps a wire has shorted to ground.
  11. R

    No blocking diode in slow mode VE115TLETS wiring harness????

    Flywheel magneto system can produce spark that can jump up to 1/2"----You need to test the health of the system.----Wires going to the fuel pump are for the " no oil " warning system !-----Flywheel key checked ?
  12. R

    1978 Evin 70HP starts and runs great but after 10min or so bogs

    Inspect fuel pump diaphragm.
  13. R

    1978 Evin 70HP starts and runs great but after 10min or so bogs

    Find the tan wire near top of cylinder head.-----Slide rubber boot away to expose metal connecter.----Turn key to ---" on "----Touch connecter to a head bolt.-----Horn should sound.
  14. R

    No blocking diode in slow mode VE115TLETS wiring harness????

    ?????----It has been stated that your motor does NOT have the slow system !----Why keep referring to it.-----I have never seen compression values that high on one of there crossflow motors.-----Use a timing light and see if there is spark on all four leads !-----Are the wires from powerpack to...
  15. R

    need help no start

    Charge the battery and test for spark.
  16. R

    No blocking diode in slow mode VE115TLETS wiring harness????

    Only has one powerpack I believe.----Does spark jump a gap of 3/8" or more on all leads , yes or no?----And post the actual compression values here.----There are no wires going to the carburetors !-----The temperature switches are only there to sound the overheat alarm !!-----Are carburetor high...
  17. R

    1978 Evin 70HP starts and runs great but after 10min or so bogs

    Well----The factory put a warning horn inside the control box.
  18. R

    1978 Evin 70HP starts and runs great but after 10min or so bogs

    Post the actual compression values that you have now.-----Did you install a new impeller ?---Have you tested the overheat horn ?
  19. R

    140 Hp stern drive

    The factory manual would be all you need.----Look for manuals on ---E-BAY.
  20. R

    140 Hp stern drive

    You have an OMC stern drive.----Well----30 ohms is way too much.-----Should be about 5/ 6 ohms I think.-----Sounds like a shaft spline is stripped.-----Fairly common.-----Time to take the drive apart.------Manuals are available.-----Your location ?
Top