Search results

  1. S

    98 Johnson leaking hydraulic fluid.

    Are you talking about the tilt tube on the starboard side that goes into the tilt bracket? When you can't get grease in any of the fittings.... it's a real chore. Usually need to pull stuff apart and clean. They sell a little tool that you put oil in and then hit it with a hammer and it's...
  2. S

    91 Johnson 50 Hesitates w Reduced WOT RPMs

    Sounds like a fuel supply issue.
  3. S

    Correct Float Seat Assembly for 1995 J48ESLEOS

    It looks like someone put a 55hp carb on there. Search repair parts for this engine.
  4. S

    Correct Float Seat Assembly for 1995 J48ESLEOS

    Here is two numbers for your carb.....maybe someone put the wrong carb on it.
  5. S

    Starter or solenoid ?

    What is the voltage at the starter when you turn the key?
  6. S

    Starter or solenoid ?

    Are you sure that's a 95? Post model number.
  7. S

    Water pressure gauge install

    Should be a little brass pipe plug. Edit: check that, when I look at the stock kit it comes with this....so I would look there. 126776 — ELBOW, EXHAUST COVER
  8. S

    Starter or solenoid ?

    Seems like something is stripped in the starter. You can hear something spinning.
  9. S

    Motor won’t turn over

    I'm thinking the nutruel safety switch on the starboard side.(mines on that side) When in nutruel it grounds the soloniod which makes it work. To test, put a jumper from any engine ground to one of the small leads on the solenoid. Should be the one closer to the back or the one that DOESNT have...
  10. S

    Mercury 25hp EFI Sucked Up Debris, Overheat Alarm

    Good to hear you were successful and thanks for letting us know!
  11. S

    6.5 hp evinrude start but won’t run

    Didn't know that was a video....that's not running at all. Check for GOOD spark.
  12. S

    Lower unit stripped drain plug

    I'm not really good at putting them in but I wonder if you could put a heli- coil in.
  13. S

    6.5 hp evinrude start but won’t run

    Try pumping the primer ball when it first starts up.....if that doesn't do it then you will probably need to go through the carbs.
  14. S

    e50tslecc evinrude

    You have something very strange going on. If you can post a video of the carbs opening and closing with the motor off.
  15. S

    Should I buy this 1973 Evinrude 65 triumph?

    I would tell him you will haul it for free.....which might be to much.
  16. S

    Stuck water pump impeller

    Good to hear....happy fishing.
  17. S

    2014 20 hp overheat sensor?

    Is this a tiller motor?
  18. S

    2014 20 hp overheat sensor?

    Kelp is tough to get through, sure it's not just your prop trying to get through it?
  19. S

    Johnson 9R-73B fuel leak

    Online or your Evinrude dealer....or whatever they call themselves now.
  20. S

    Johnson 9R-73B fuel leak

    The fitting from the tank doesn't look new in the picture. Anyhow, I've had problems with the aftermarket ones.
Top