Search results

  1. flashback

    Converting from vertical 2x4 to horizontal 2x6 bunks

    I think your over engineering it a bit but it's your boat. fillet is not necessary IMO. and even using yellow pine lumber will last you many years, The PT lumber these days ain't what it used to be..
  2. flashback

    Converting from vertical 2x4 to horizontal 2x6 bunks

    I agree with the above posts but if I wanted to do what you suggested I would just glue and screw the 2x6 on top of the 2x4..
  3. flashback

    Troubleshooting a leak

    It doesn't look life threatening, my kitchen faucet drips more. Another option is the seal for the raw water tube, they can take a beating when changing the hose..
  4. flashback

    Troubleshooting a leak

    Pic's a little dark but your arrow seems to be pointing at the hull drain, you didn't forget to put the plug in did you?
  5. flashback

    Speedometer tube

    Don't see why not, but you'll need the fitting to fit the drive.
  6. flashback

    Plastic Tanks are All Junk

    This is something that I will be sure to remember! Thx
  7. flashback

    Gas cap replacement

    Most all I have seen have a tether on them so don't be too hard on dockboy..
  8. flashback

    How to test bonding/grounding using a multimeter

    Battery - post
  9. flashback

    Can water get into oil from failed exhaust parts?

    Why did you take it apart?
  10. flashback

    Can water get into oil from failed exhaust parts?

    Valve position has no effect on the pressure test.
  11. flashback

    Can water get into oil from failed exhaust parts?

    I don't believe there is a practical way to pressure test manifold or elbow. That test is done with acetone.
  12. flashback

    Lubricating throttle/shift cables

    Some controllers have a tension adjustment or the controller itself may need attention.
  13. flashback

    Wiring Fuel Pump Relay to Alternator

    I pulled power from the + on the coil, it was close to the relay. No problem yet. My goal was to keep the wiring simple and compact.
  14. flashback

    Boat dies in the water

    That's interesting, how did it end up down there?
  15. flashback

    Should there be a Sleeve Propeller Bore on 200HP Merc 3.4L V6

    Do you think it may have a steady miss?
  16. flashback

    Replacement long block

    I would study your engine room and imagine having to work on the motor. Any components that are impossible to get to I would replace with new. Fuel pump or starter in my case..
  17. flashback

    Boat dies in the water

    Looks like you may have the wrong prop and certainly some mis-matched parts. I know only what mine looks like and that ain't it. The shaft is probably ok with a bit of work..
  18. flashback

    Boat dies in the water

    Something don't look right. The nut is too small for the locking ring. You may need to remove the prop and be sure all the parts for the hub are there..
  19. flashback

    Hard starts after sitting for a week or so

    late to the party, but make sure that it opens completely when warmed up.
  20. flashback

    Throttle cable issue

    If you feel you can DIY there are many here that will guide ya. If you are not of that nature then find a mech who is better than the last one... I have crapped out many times but I learn from the folks on this forum. many have done this stuff for a livelihood and are willing to help... Welcome...
Top