Search results

  1. nola mike

    2000 Sea Ray 5.7EFI alpha 1 gen2

    I think @achris has posted about this, but I can't find it ATM EDIT: Found this one, but I'm sure there are more...
  2. nola mike

    Mercruiser 3.0 fuel delivery issue

    Not sure where you're putting the hose, input side of pump and then disconnected carb? And that flows, but when input side of pump is connected to tank it doesn't flow anymore? If that's the case, you have a restriction between the tank and pump. Either anti-syphon valve, in tank filter/sock...
  3. nola mike

    2000 Sea Ray 5.7EFI alpha 1 gen2

    But should be able to seat fully and will function normally either way with either bearing, right?
  4. nola mike

    2000 Sea Ray 5.7EFI alpha 1 gen2

    I thought they could be installed in either direction, but MCM specifies the direction so that you can't just remove the inner race and bearings, you need to replace the whole thing.
  5. nola mike

    Mercruiser 3.0 fuel delivery issue

    Nor a glass inline filter. From what you're saying though, either bad fuel pump or restriction before the pump. I'd start by checking fuel pressure though. If you run on a remote tank and the motor works when squeezing the bulb I'd guess fuel pump.
  6. nola mike

    3.0L hard starting when warm

    Ok, I'll take a stab, but I don't have the actual wiring diagram to look at (@alldodge ?), so making a few assumptions, correct me if those are wrong. Also, one of the assumptions is that the 3.0 still has a mechanical fuel pump and doesn't need the diode and fuel pump connections? 1. You...
  7. nola mike

    What can cause this to shift bellows ?

    agree it looks twisted/stretched. I can't see any clamp or tie on the aft side? Also possible if there wasn't enough slack left in the bellows it could stretch it when you tilt the engine. I'd think less likely rodent damage since it looks deformed in addition to the holes
  8. nola mike

    Dry carbon fouled plugs 120 hp mercruiser

    Depending on your electronic conversion you shouldn't need a resisted coil. Also, have you checked to make sure your choke is opening fully?
  9. nola mike

    Info on Mercruiser 0A494867 170Hp engine.

    Not easily. Did I miss what the issue is with the current motor?
  10. nola mike

    Starter Slave Solenoid?

    Could be, could also be wiring anywhere from your ignition switch back, starter itself... https://forums.iboats.com/threads/how-to-troubleshooting-your-engines-starting-system.166663/
  11. nola mike

    Won't start.

    https://forums.iboats.com/threads/how-to-troubleshooting-your-engines-starting-system.166663/
  12. nola mike

    ANOTHER WATER IN OIL QUESTION

    Manual specifically states not to use sealer on composite gaskets.
  13. nola mike

    Inaccurate fuel gauge?

    Yes, this is the main problem. It's a shallow, below deck tank at the stern. It's pretty much impossible to set it up to read anything less than full until it's less than 3/4, and usually then only when off plane. Guessing the extra stern weight of the new engine isn't helping. Using a regular...
  14. nola mike

    Inaccurate fuel gauge?

    Replaced the sender a few years back. Went through great pains to get it sort of accurate. This year noticing that it's always full. Until it isn't. Realized that it's probably because I cleaned up some connections in the helm, and the gauge is now seeing lower resistance. I don't particularly...
  15. nola mike

    Info on Mercruiser 0A494867 170Hp engine.

    Plenty of help on here to get your 3.7 running. What issues are you having? No such thing as a reliable 35 year old boat. The 3.7 is no more or less reliable imo. Now that @Eric 3.7LX Alpha 1 is back, you're in good hands. If only we could find @stonyloam...
  16. nola mike

    Mercruiser Service Manual #10

    Well... Not quite. You need an old browser version, and your computer needs to think that it's 2020
  17. nola mike

    Another blown head gasket - Fuel Mixture?

    The idle mixture affects idle, once off idle the idle ports don't do anything.
  18. nola mike

    170 MC, 1985 Seville, 21 foot Mid Cabin

    You may have had some water enter the cylinders through the exhaust and hydrolocked. That's very low...might try some thicker oil, but no magic. Where is the water? Mixed with the oil or in the bilge?
  19. nola mike

    ENGINE NOT STARTING...KICKING MY BUT

    You can use an auto coil.
Top