Search results

  1. C

    1995 Johnson 130 No Power Under Load

    2 years sitting....have you serviced the carbs ??? as a bare minimum have you cleaned out the High speed orifices the bottom of the carbs ...just behind the lower carb bolt have you checked all filters incl. tank pick up ??
  2. C

    What type of hydraulic fluid to use in '98 50hp Johnson? Replace relays too while I'm at it?

    btw my 75hp ETEC was doing the same.... in my case a T&T reseal was in order. been ok since :)
  3. C

    What type of hydraulic fluid to use in '98 50hp Johnson? Replace relays too while I'm at it?

    cylce the system a few times to purge any air...keep topping the oil after every cycle till 100% full
  4. C

    Looking for Service manual for 1982 evinrude 2hp (E2RCNE) outboard

    what compression #s do you get ... if OK don'T mess with it just do the top side stuff ! http://www.leeroysramblings.com/OB%20carburetor_repairs.html http://www.leeroysramblings.com/Troubleshooting%20OB.htm http://www.leeroysramblings.com/johnson_magneto.htm
  5. C

    Looking for Service manual for 1982 evinrude 2hp (E2RCNE) outboard

    not much to service on a 2hp what issues do you need the book for ??
  6. C

    Strange leak on 9.9 Johnson

    16mb file... !! I am not openning it.
  7. C

    AC lightning plug on Evinrude / Johnson outboards

    6 year old topic..... best to start a new one. search the net for parts 3 pin plugs are common some folks use solar panels to trickle charge their batteries
  8. C

    9.9 johnson outboard recommended oil?

    usual twc3 at 50/1 regular gear case oil see article below http://www.leeroysramblings.com/Johnson%209.9_15.htm
  9. C

    76 Johnson 15 HP

    if electricals are ok , compression is OK carb is clean then fuel combustion is inadequate either from poor delivery from the carb (TBD) or inability to pull the fuel from the carb due to vacum loss in the crankcase (seals) . can you at least feel a good pull of air on the carb face ?
  10. C

    76 Johnson 15 HP

    magneto cam arm and carb adjusted (synch'd) do you see the throttle and throttle pale reaching their maximum range ?any exhaust obstructions ? does it pick up speed if you shoot some fuel mix in the carb ?
  11. C

    76 Johnson 15 HP

    back to basics ... compression #s OK ???
  12. C

    76 Johnson 15 HP

    i'll try...to remember
  13. C

    76 Johnson 15 HP

    I can never remember which is starboard... only left and right looking forward :) and I do not have to many years to learn so for me it stays left and right :) This is the transcript of a radio conversation of a US naval ship with Canadian authorities off the coast of Newfoundland in...
  14. C

    76 Johnson 15 HP

    the points that " open "at TDC of a piston belong to that piston...
  15. C

    76 Johnson 15 HP

    when one piston is at top dead center ....... one set of points should be open usuall y .020 or begin to open That cyl. the one associated with your , coil and plug wire and plug wire & point to find TDC (approx) poke a small screw driver in the sparkplug hole & turn the FW till you...
  16. C

    What to jump on old Johnson 65HP

    drawing is presumably for a 72 you have a 73 so expect small changes....or none
  17. C

    What to jump on old Johnson 65HP

    here is a 72... 65hp wiring https://maxrules.com/graphics/omc/wiring/1972_65_Eshift.jpg
  18. C

    What to jump on old Johnson 65HP

    engine model# ???
  19. C

    1959 Johnson seahorse 10hp qd-20 wont idle and need bracket

    qd 20 is listed as pressure tank engine unless modified....to pump.. assuming carb is clean and adjusted..... running out of fuel is indicative of loss of pressure to push the fuel back to the carb , hand pumping the primer button should confirm this as it will refill the carb filter...
  20. C

    69 9.5 Evinrude spuddering/coughing

    plastic plug... I would rebuild the carb as per design intent. pass as small 2lb mono in all orifices (channels within the carb) btw change the float if you have doubts or a spare one.... check for any missing lead plug in the carb body not much else you ca do.
View older results
Top