Search results

  1. Faztbullet

    1991 Mercury 40HP “Classic” Plug Fouling/Stalling

    Total internet BS as someone thought they understood how ADI ignition works. How old is fuel? Are you premixing as looks to rich on oil ratio? Is oiler still hooked up? if so look to see if metering rod to carb has popped off
  2. Faztbullet

    CDI troubleshooting question for 1990 90hp V4 crossflow rectifier/regulator

    Nope.... A lot of people coat the rect/reg mounting gasket and forget to install the grounding washer on the bolt. This will cause a weak ground between rect/reg and block and diode cannot bleed off and fails.
  3. Faztbullet

    Flywheel movement

    Check your gear oil,,,
  4. Faztbullet

    1999 yamaha 2 stroke 9.9 to 15hp conversion

    The reeds are less restrictive due to stops and larger intake area...
  5. Faztbullet

    Mechanics opinion needed on a 90HP Merc Four Stroke

    Call the below as they show one in stock.... https://www.powerhousemarine.com/
  6. Faztbullet

    2004 merc xr6 150 oil tank question

    Yes ...below starter. Part #878101
  7. Faztbullet

    2004 merc xr6 150 oil tank question

    Crankcase pressure valve is bad on block.
  8. Faztbullet

    Evinrude 200 ficht

    PDP or relay
  9. Faztbullet

    1998 Lowe 245 with 225 HP Evinrude Fitch motor

    The switch is a mechanical kill and will run with lanyard removed as grease in it has stiffened. The lanyard holds it against a internal detent and is spring loaded. if removed the switch will return the key to off setting. Make sure it turning at least 300+ RPM or the CPS will not sync with ECM.
  10. Faztbullet

    Is it bad to run a pwc out of the water?

    Jet ski use aluminum or SS impellers. They are blowing out the exhaust..wont hurt a thing on em unless in excess of a couple of minutes.
  11. Faztbullet

    2003 Johnson 90hp 2-Stroke Stator & Regulator Rectifier Issues

    Good ole CDI quality control strikes again.......
  12. Faztbullet

    2005 Optimax 135HP voltage drop.

    Will have to take alternator to a rebuild shop as parts not sold to repair it. A lil Google search you will find one in my area (Kingsport TN) for $100 USD
  13. Faztbullet

    1978 Mercury Black Max V1500, Surging at high throttle.

    Need to get rid of the automotive spark plug wires and get solid core back n there
  14. Faztbullet

    1992 Mercury 175 Head Sensor Looks like PCV valve

    Nope...what series carbs ya got? Do they have the accelerator pumps?
  15. Faztbullet

    1992 Mercury 175 Head Sensor Looks like PCV valve

    Nope.....just line to carb as that restricts air to carbs. makes it riches at warmup
  16. Faztbullet

    1978 Johnson 70HP head scratcher

    Hillbilly told ya it wasnt reeds..but you just had to chase that rabbit. Rebuild the original OEM pump
  17. Faztbullet

    Is this steam normal.. 1984 50hp Mercury

    That is a non thermostat engine and uses internal restrictions in block/cover to control water flow and volume. It should have 2-5 psi at 2500 RPMs and 7-12 psi at WOT. Use a 15 psi max guage
  18. Faztbullet

    1978 Johnson 70HP head scratcher

    Yep...bad reeds take out packs............NOT
  19. Faztbullet

    Amazing

    No the V-6 115 was a slow seller
  20. Faztbullet

    Cylinder Compression Incongruences.-

    How about a pic of #2 with piston removed as sleeve doesnt look tight to aluminum
Top