Search results

  1. R

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    Buying individual seals for this motor adds up.----Do not restrict your search to a 1982 model.-----Lower units kit is common for all years of the 9.9 / 15 HP.-----About $46.99 list price for correct kit.----Fits from 2005 down to 1980 models.----Your local dealer will help you find this correct...
  2. R

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    Sorry ----you have to do a better search.-----Not correct.
  3. R

    2000 70 hp

    Buyer beware!-----There are known issues with cooling on #2 cylinder .
  4. R

    Looking for some help

    Gear oil has nothing to do with the motor running as you describe !!
  5. R

    94 Johnson venom 200 Bogging in forward

    You do not have full power in reverse.-----The prop is turning in water / exhaust and allows it to rev up easily.----Just sounds like it has full power.----Are wires FROM the powerpack going to the right coils ?-----With motor idling pull plug wires off one at a time and listen for change of...
  6. R

    Trim and tilt question

    Post a picture from the SIDE ( prop level ) so that helpful folks can see the position of anti cavitation plate relative to bottom of the boat.
  7. R

    Evinrude 130

    I usually do not assume and think.----I do some simple testing.----But I can not see , hear or touch your motor !!
  8. R

    Evinrude 130

    Pulse limiter removed ?----That pump might be marginal to provide enough fuel.----So have your assistant operate the manual pump and test run.-----And perhaps test run with a portable tank mixed at 50:1.----Motors all run fine on muffs.----Even in gear on the trailer is still neutral, as prop...
  9. R

    Evinrude 130

    Part # of the pump ?
  10. R

    Evinrude 130

    Post #1 mentions ---" fuel pump " -----Can you elaborate on that.----It means nothing to me as stated.----And does spark jump a gap of 3/8" on each lead using a test device.
  11. R

    Evinrude 130

    You can not bring it over.----So post the compression test values.----Can be an important clue.
  12. R

    Evinrude 130

    The electric primer valve puts fuel directly into the intake air.-----This fuel bypasses the carburetor metering circuits.-----This points to a fueling issue.-----Checked for warped carburetor bowls ?----Water in the fuel ?
  13. R

    1983 evinrude 115 mystery hose

    It is to provide pressure to a speedometer.----Simple as that.----I believe that lower unit is a replacement and not an original to 1983.
  14. R

    Engine cutting off high rpm .

    There are known issues with #2 cylinder.
  15. R

    2000 70 hp

    Buyer beware.
  16. R

    Engine cutting off high rpm .

    That 120 is not a good omen.-----
  17. R

    1971 Reinell

    Have a good look at transom , stringers and wood structure.----These 50 year old boats often have issues.
  18. R

    carburetor swap

    I guess it can't be lost because somebody pulled the wrong switch somewhere.-----The only drawback is that 30 year old cards are not updated with superceded part numbers.
  19. R

    Trim and tilt question

    Say that again , confusing to me.
  20. R

    Stern Drive Mystery

    In gear on muffs is still neutral as the prop does no work moving air.------In the water the prop puts a load on the engine.----If the motor is in poor shape ( needs tune-up ? ) it can not do the work.-----An 200 HP engine does not produce 200 hp while idling.----It only produces enuff power to...
Top