Search results

  1. 9

    Yamaha 115 ETLK wiring

    ETLK does not make sense to me
  2. 9

    1984 Yamaha 25 hp SN No Spark

    I am not sure what the 2nd wire to the pulser coil is suppose to be. is it just to ground?
  3. 9

    1984 Yamaha 25 hp SN No Spark

    do a web search for CDI electronics trouble shooting guide. it will give you the basics on what and how to test the kill switch ground the spark voltages to stop the motor/spark. that is where I would start looking if you have good peak voltages out of the charge and pulser coils
  4. 9

    Using hose flush to cool engine.

    have any of you looked at the size of the tubing that the hose screws onto to put water into the motor? not much water can get thru there for cooling. it is fine to use it, but if you want to run the motor, also use muffs to add water and lube the pump
  5. 9

    Suzuki 140 1995 Outboard Spark Plugs

    I believe the 5 is a hotter plug, keeps from fouling as quickly, but may cause detonation/pinging (fuel being set off before the spark happens)
  6. 9

    New Yamaha 8hp

    could be the prop or one cylinder not firing properly
  7. 9

    New Noise - 2002 Yam 90hp 4 stroke

    how they could go against the flow of water is surprising
  8. 9

    New Noise - 2002 Yam 90hp 4 stroke

    I sure hope you can find all the pieces to keep from having plugging in the cooling passages and overheating problems
  9. 9

    Overheat / dry run Yamaha 115- Need advice

    service manual for your motor will have all specs
  10. 9

    Yamaha F175XA Cooling System Problem...help?

    also when putting a bucket under lower unit to run the motor, you need to be sure the water level is high enough to cover the water pump itself. Not just the water puck up screen. that pump has a hard time sucking on air to get the water up to it
  11. 9

    New Noise - 2002 Yam 90hp 4 stroke

    you are correct, it should not overheat if the TT is just plugged, but you have no idea if that is the problem or not, unless you check it out or run it until it does overheat
  12. 9

    New Noise - 2002 Yam 90hp 4 stroke

    when you start a motor make sure the lower unit is in water deep enough to cover the water pump not just the intake screen. Do not start motor out of the water unless you hook up a set of muffs and turn the water hose on full blast. every time you start the motor look and make sure the tell...
  13. 9

    New Noise - 2002 Yam 90hp 4 stroke

    do you have gauges that indicate what alarm is happening? probably overheat or low oil pressure my guess is over temp it is never a good idea to keep running a motor that has a problem. you should shut down the motor as soon as possible to try to correct the problem. was the tell tail showing...
  14. 9

    2005 Yamaha 50 4 Stroke Poor Water Flow at Telltale

    Blowing a little compressed air up the TT is a lot easier to see if that helps before tearing things apart
  15. 9

    2005 Yamaha 50 4 Stroke Poor Water Flow at Telltale

    have you tried blowing some compressed air up the tell tail while running motor on muffs or in the water to see it that moves things around out of the way to clear the passages?
  16. 9

    What does the choke do on a Suzuki EFI??

    maybe if the IAC fried while in the mostly closed position and then did not open up to let enough air in during the start up process the motor would not start due to too rich mix. opening up the throttle with the lever allowed it to fire up but at way to high of RPM and no way to control it...
  17. 9

    Yami 9.9 screams in neutral

    2 things can affect RPM, throttle linkage and timing, a timing light will tell if the timing is too far advanced at idle did you look at the throttle plates to make sure they are closing back to Idle position?
  18. 9

    2005 Yamaha 70B running rich

    disconnect the solar charger, run the lights or t&t for a little bit and then measure the battery voltage. then start the motor and see what the battery voltage reads while the motor is running, if it is not higher than before you have problem with the system charging system
  19. 9

    2005 Yamaha 70B running rich

    should get the voltage from the lighting coil while motor is running. if the battery being charged while motor is running? trace wires , measure voltage . make sure the ground has a good connection
  20. 9

    What does the choke do on a Suzuki EFI??

    manual choke levers were on the motor itself, incase the electrical part failed to work. carbed motors only
Top