Search results

  1. Scott06

    Car Tires ok?

    I ran car tires on my trailer for several years like this short distance towing never had an issue.
  2. Scott06

    Tin Rig Tow Vehicle

    You two aren't the only guys left... used to tow my dads 22 ft Catalina swing keel and my sea ray 170 with a honda accord coupe ... Also used a Volvo 240 wagon and a Taurus over the years ...
  3. Scott06

    Mercruiser 3.7 / 470 Holley EFI Sniper.

    Glad to hear it worked out no photos were attached though... Is it running?
  4. Scott06

    Making sure I purchased the correct coil for a 1996 5.7L

    if your timing spec is 8 it should be at 8 in base mode not 0. It is usually on the flam arrestor and also in the shop manual. When you come out of base mode you will see the ignition module advance it some as the TBV is an active system where it is changing the advance based on engine conditions
  5. Scott06

    Cracked 5.7 engine

    Real repair is to replace the engine. But If you are lucky enough that it doesn't get into your oil after a couple of good hard uses , JB weld the crack and it is what is ... There is something called lock and stitch to repair cracks but would think it wouldn't be worth it in this...
  6. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    Its your thread ask what you want, whole idea is to learn. At least I'm not the only one who calls it a kill switch ...
  7. Scott06

    1997 Merc 4.3 V6 LXGen+

    Would second this. Marine engines under load have a much higher detonation potential than automotive applications, detonation that can eat your engine for lunch in a short time. Would suggest getting a timing light and setting it properly and verifying total advance
  8. Scott06

    2001 Glastron GX205. Windshield.

    Have you contacted Taylor made with the numbers off your windshield ?
  9. Scott06

    Reputable engine source?

    Would also recommend Michigan Motorz. I had a very good experience with and partial engine package (New base engine , intake carb, ignition). On its seventh season no issues . Link to their vortec 4.3 base engine but they have remans to turnkey bobtails...
  10. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    Yes with key in run position and kill switch on you should have 12v to purple wire on positive side of the coil. Tripping the kill switch should interrupt 12v to positive side of coil. If it doesn't kill switch is bad or someone jumpered around it because it was bad...
  11. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    Yes you need the sensor based off your tests. The kill switch interrupts the 12v supply to positive side of coil (purple wire). That was in the beginning of the troubleshooting guide. You may want to look at the distributor I think to remove the sensor the rotor and trigger wheel needs to come...
  12. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    Did you ohm test the coil ? if it passes the ohm test it is good... or just reinstall it and go through the trouble shooting
  13. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    would add a fourth if you are getting spark off coil itself cap and rotor could be a problem area. Can loose spark there
  14. Scott06

    2005 Mercruiser 5.0 thunderbolt V ignition has no sparks

    This shows how to trouble shoot the system https://forums.iboats.com/threads/how-mercruiser-thunderbolt-ignition-systems-work.676476/ should be able to ohm the coil .6-.8 ohms on primary side, 9400-11700 ohm on secondary side
  15. Scott06

    Mercruiser 120 Instrument wiring

    down this thread has two versions of a similar vintage merc helm wiring no purple and white, but there is a red and white (possible its faded?)associated with the key switch https://forums.iboats.com/threads/dwell-on-a-mercruiser-165.709438/page-2
  16. Scott06

    Volvo 5.0GXI Overheat/New thermostat

    It does as long as no flow is going past the pump not sure if it will hold back the water and force it towards the drive
  17. Scott06

    Is this a concern?

    Who said anything about a Merlin? Sounds like a good swap though ...
  18. Scott06

    Mercruiser 5.0 Won’t Reach Operating Temp

    this or the gauge is inaccurate. If you have a suspect impeller replace it now as its only $50 of parts
  19. Scott06

    Volvo 5.0GXI Overheat/New thermostat

    It will not come out the exhaust only the water intake ports in the drive I would assume it is the hose that has a flush port on it but I'm not looking at your boat... One of the hoses to the pump will go up to the thermostat housing the other will go back to the transom housing - the one that...
  20. Scott06

    Trim motor bracket replacement....

    Yes just screw into the deck. I would put something like 5200 in the screw holes as a sealant to keep water from getting into holes.
Top