Search results

  1. C

    1967 J.E. 9.9hp coughing/stuttering

    may as well post the model #...
  2. C

    1984 Johnson 40 hp rectifier question

    if it does not regulate... ( diagram shows a simple rectifier) & consist of only a 3 phase rectifier they are dirt cheap https://www.amazon.ca/Bridge-Rectifier-Phase-Diode-Aluminum/dp/B07BGR2JFV/ref=sr_1_7?dchild=1&keywords=3+phase+rectifier&qid=1605197944&sr=8-7 yellow wires carry AC...
  3. C

    high speed needle

    see picture
  4. C

    Classic Johnson 4hp twin 2-stroke

    the more things are easier to work with the more complex and expensive they are to fix :-( Even my new Chistmas lights are remote controllable from my warm living room & they can blink fade or stay steady with sealed multi-color LED "bulbs". If they fail me.... sorry WHEN...
  5. C

    Classic Johnson 4hp twin 2-stroke

    ok tanks I was looking at the 80 ish years only except 80 of course :-( never worked on those cdi.... any worse to figure out compared to magneto old stuff ??
  6. C

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    save your money and buy a new fishing rod ....you can adjust it in the Spring :-)
  7. C

    Classic Johnson 4hp twin 2-stroke

    up to 1986 they seem to use standard od style magneto parts
  8. C

    Classic Johnson 4hp twin 2-stroke

    coils probably ok just clean the points with a business card and carb cleaner for now 24/1 oil won't hurt it change impeller and change gearcase oil look .....for water in the gearcase oil if ok (none) just refill with gearcase oil clean or replace plugs try it out...
  9. C

    Tilt mechanism 82 Johnson 7.5 hp

    hum....locked down for 9 years... ??
  10. C

    1957 big twin 35, electric start

    I think you will find some info on the relief valve adjustments page 535 section 12 of the johnson red book http://www.boatinfo.no/lib/johnson/manuals/1922-1964johnson.html#/558 you can read up on the whole section as it applies to a starter installation but section 12 syas the...
  11. C

    Locked down 7.5 Johnson

    tried in R-N-F mode ?
  12. C

    1964 18hp spark fail #1 cyl

    what ohms resistance do you measure on your coil secondaries at the boot end of the spark wires use the proper scale (above the expected reading) ex: 10,000 ohms scale if using an analog (needle) meter (digital meters will self adjust)
  13. C

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    the smaller hose clamps do a good job to and easy to screw down tight...
  14. C

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    sludge is normal just..... unburnt oil carbon fuel etc.....
  15. C

    Electric start with push button.

    the selenoid is for the transfer of high amperage load to the starter with the shortest route possible key contacts will burn up otherwise.
  16. C

    Electric starter and rectifier

    I am not to worried about the charge amps. the amp load & voltage to run the starter is the critical one for 3 reasons . a- voltage drop on a long run due the a " to small" cable per/foot resistance b- amp requirement for the starter c- amp rating of the cable itself...
  17. C

    Electric starter and rectifier

    Just curious, the kit seems to come with the wires needed for the job. why would you want to go "smallest wire possible" ? . I am certain the manuf. did not incl. a wire size "bigger" than what the installation needs at an added cost for no reason. the kit seems more expensive than a...
  18. C

    No Crank

    Great news thanks for the feedback LOOKS LIKE RED/PURPLE WAS THE MAIN +12V FROM THE FUSE TO THE KEY "B" POST......via the side plug ! http://www.boatinfo.no/lib/evinrude/manuals/1971-1989johnsonevinrude.html#/626
  19. C

    1993 40 hp evinrude won't start

    http://www.boatinfo.no/lib/evinrude/manuals/1990-2001johnsonevinrude.html#/0
  20. C

    1959 Evinrude 5.5 alive again - water pump replacement?

    pulling the PH isn't as bad as it sounds ... been there just follow the video carefull with the top of the drive shaft when removing the PH (small parts (carbon) o-ring etc,,. carbon seal is very brittle...
Top