Search results

  1. R

    Do I have a bad starter?

    Did you have the battery load tested ( even if nearly new ) at a battery retailer ?----These starters are easily damaged by excessive cranking.----They are also elegantly easy to inspect if you have a digital ohmmeter.-----But some folks are afraid to take them apart.-----They opt for the "...
  2. R

    2000 model year Johnson J175XVSSS gearcase removal

    Push the shift lever to the port side I think.
  3. R

    Motor stalls in neutral

    Well----OPEN to ground sounds like it is a good stator.-----Revisit your test procedure / specifications.
  4. R

    1986 Johnson 40hp short circuit

    Easy to test stator with flywheel in place.-----Find a used regulator on E-BAY ??
  5. R

    Parking on incline

    ???----Build the wood block.-----Put wood block under trailer right in front or behind where the jack is now.------Or simply buy a hefty jack or 2 .
  6. R

    Parking on incline

    Lift it up.-----Put wood locks under it.----Lower trailer onto the wood blocks.
  7. R

    58 Evinrude 7.5 tiller adjustment

    Fact.-----Removing the powerhead on the 7.5 allows you to service the critical mechanical seal at the top of the driveshaft.-----And also that feature means that there is no shift rod connecter to mess up.-----Clutch dog is always engaged correctly !!
  8. R

    58 Evinrude 7.5 tiller adjustment

    The motor is 64 years old.-----Pretty well all metal and no fragile plastic parts.-----Some still run like new.-----A very good design I would say.
  9. R

    58 Evinrude 7.5 tiller adjustment

    Well----There is a tension screw installed at the factory.-----Look for it and find it.
  10. R

    58 Evinrude 7.5 tiller adjustment

    Take motor off your stand.-----Look between the transom clamps to find the adjusting screw.
  11. R

    58 Evinrude 7.5 tiller adjustment

    Let me go look at one ------Back in 10 minutes.
  12. R

    58 Evinrude 7.5 tiller adjustment

    Yes there is a screw that you can tighten to make it harder to tilt up.-----Or there is a tapered friction block in the grip to make TURNING the grip harder, so it stays steady.
  13. R

    1996 Johnson 9.9 Carb Studs

    Find a bolt long enough.----Put some more thread on it.----Cut off the bolt head and there you have it.
  14. R

    1992 E10RELENA won't go over 3k

    Some simple trouble shooting will find the issue.----Also check flywheel key ( timing )-----And no you can not find a sheared key with a timing light.----Good luck with it.
  15. R

    93 Mercury classic 40HP ran perfect and now dies intermittently

    Step #1 is see if you can find a shop willing to take on this kind of work in the summer season.
  16. R

    82 Evinrude 115hp: How to run on stand?

    Go from battery post on the solenoid to one of the wee terminals on the solenoid .-----Manual operation of PRIMER SOLENOID first.----Then crank and start it.----Supply water to impeller.-----Motor will need to be stopped by running out of fuel or primer valve OPEN
  17. R

    93 Mercury classic 40HP ran perfect and now dies intermittently

    Too late now.------Was oil injection working ?----Water pump impeller should be replaced on a " new to you motor "-----A new motor will be sticker shock.-----Myself I would rebuild it.----They are a great running motor when maintained----Blunt statement on my part.-----Many folks learn about...
  18. R

    1964 Evinrude Yachtwin

    Simple motors.----Just nuts and bolts.-----------leroysramblings------May give you the confidence to take this on.
  19. R

    1983 Johnson 115 hp not coming up to full power

    Ask around your local boating community.---Or buy a rebuilt powerhead and install it yourself.----These motors are famous for broken rings.-----Anybody doing this work will have done a few of them !
  20. R

    82 Evinrude 115hp: How to run on stand?

    That wire can stay on the starter motor.
Top