Search results

  1. R

    1995 Evinrude 15 HP Shift issue! Please Help!!

    Propshaft has to be turned when you shift on a work stand.-----Or motor must be running to shift properly.----Simple as that.
  2. R

    Need a little help 150 evinrude intruder lower unit

    Reverse does not do a lot of work.----It is almost always fine.-----Remove nut on bottom of driveshaft and remove driveshaft.----Then push shift rod all the way down and remove it.----Then pull out propshaft.
  3. R

    Towing more than capacity?

    It sounds to me that the bowl goes empty.----Those motor typically then rev up before they stop.----Easy to solve this I think.
  4. R

    Yam 85 Losing Power.-

    Clean out the entire cooling system.----From water intake screens right to all the water jackets and covers.----Will run like new again.
  5. R

    1975 Evinrude 25

    I can not see or hear your motor.-----But the motor speeding up tells me it is running out of fuel.-----In my opinion this is an easy fix.-----Could also be a bad reed valve causing low crankcase compression.-----The + crankcase PRESSURE pulse drives the fuel pump.
  6. R

    1975 Evinrude 25

    When the carburetor bowl is near empty an outboard will rev up.----Test run with another hose and tank.-----Some cheap plastic tanks have issues with pick up tube inside the tank.
  7. R

    Towing more than capacity?

    Towing down the street to the launch or a 100 miles at highway speeds ?-----How steep is the launch ramp ?
  8. R

    1975 Evinrude 25

    I believe it is running out of fuel.----So check your fuel line o-rings in the fittings.-----Step #1 in trouble shooting is always the same.----Post your compression test numbers.----
  9. R

    1986 90 hp Mercury inline 6

    Those may have used that separate tank ----AKA ---Autoblend----And that unit should be thrown away as far as you can.-----The inline 6 was marketed as a 90 for quite a few years !!
  10. R

    So i decided to pull the powerhead off....

    Correct many bearings on outboards have loose rollers.-----I assemble them with needle bearing assembly grease.
  11. R

    1986 90 hp Mercury inline 6

    There is a small diameter oil recirculation line that goes from the bottom of the block to near the top bearing.
  12. R

    Optimax 150 dfi IDLE SHUTOFF

    Compression test needs to be done.
  13. R

    1996 Mercury 125 - no reverse

    The clutch dog is spring loaded and yes as it moves to reverse you have to put more effort into compressing the spring.-----And the propshaft must be turned when you shift to reverse !
  14. R

    '67 Holiday 18' - Make it Usable

    It appears ( by paint colors / markings ) that the axle is not original to the trailer.-----You might want to look into a bigger axle/ wheels / tires.
  15. R

    513031 Timing Wheel Encoder

    Put them on E-Bay------Likely a popular item.
  16. R

    A few questions from a learner

    Have to agree with Jim here.-----Outboards rarely get a chance to wear out.-----They are well built but ruined by folks.----Every day folks come up with a new method of breaking them.
  17. R

    Evinrude 9.9 over heating

    Install a thermostat !
  18. R

    Black max 175

    1996 ?
  19. R

    Any flea’s for sale?

    ?---Seaflea= small hydroplane ?
  20. R

    Merc 9.9 Impeller Long Shaft

    No difference between a long and short shaft to change the impeller.
Top