Search results

  1. R

    Johnson 50hp throttle linkage?

    Compression test must be done.----Post the numbers.
  2. R

    Shift position way off

    Good luck with it.
  3. R

    Shift position way off

    I guess I need to be more clear.---There is no adjustment possible on the connecter with the 2 wee bolts !----Propeller must be turning when you shift this motor !
  4. R

    Shift position way off

    There is NO ADJUSTMENT on the shift rod connecter.----Repeat no adjustment.-----You line up the notch in the shift rods with the hole and install the wee bolt.
  5. R

    1998 Evinrude Outboard 150 Ocean Pro Ignition Switch issue

    What key switch did you use?----What instructions and wiring diagram did you follow?----You risk major damage to Expensive parts.----Disconnect battery and read up on this.
  6. R

    frustated

    The float and float valve need attention.----Time to take it apart and revisit the work done.----Yes if you are working on your first carburetor it can be frustrating !!
  7. R

    Wrong impellar?

    Model # is required first !
  8. R

    Carb Question

    No dust out on the water.----What is your motor doing / not doing that leads you to the questions here.
  9. R

    Clockwise spinnging Starter 1968 85hp Johnson

    If in Canada----Try----evinrudeparts.ca-----See if they can help you.
  10. R

    Clockwise spinnging Starter 1968 85hp Johnson

    Send it back to the clowns !
  11. R

    Clockwise spinnging Starter 1968 85hp Johnson

    Look at it mate.------The starter has to turn opposite !-----The unit on top reverses the direction so that the motor starts runs the correct way.-----Some folks you are talking to are totally miss- informed !
  12. R

    Power pack and coil AGAIN!!!

    Are these new parts factory parts or something from AMAZON outboard experts ?
  13. R

    Clockwise spinnging Starter 1968 85hp Johnson

    Is your battery hooked up correctly ?----Is the + from solenoid going to the post on the starter ?----Looks like a rebuilt / new starter.-----Sourced from where ?------Did somebody have the starter apart ?
  14. R

    Clockwise spinnging Starter 1968 85hp Johnson

    Is this the geared down starter.----Or armature straight to the flywheel ?----Any pictures ?
  15. R

    Wont accelerate

    Wires from power pack going to the correct coils ?
  16. R

    Sharing a berth

    New owner at the marina.----Sounds like an attempt to cash in on the supply / demand for all the interest in boating.----Does the marina staff move these boats around along with taking responsibility for dock lines and fenders ?----=Sheltered location or out in the open ?----Size and style of...
  17. R

    1962 Evinrude Starflite IV 75hp no spark HELP!

    Motors today might not have replaceable float valve seats.----But in 1962 every thing was built with " repairs in mind " so yes there is a float seat in that simple carburetor.-----What other trouble shooting has been done other then jumping all over the carburetor ?----Install a new impeller in...
  18. R

    Wont accelerate

    It will rev up to 5000 RPM in neutral running on 2 of 4 cylinders.----So your test means nothing here.----Post your compression test numbers.----And check for STRONG spark.----Good spark on that will jump a gap of 7/16" on a test device !-----Easy tests to do.----If you can find a shop to work...
  19. R

    Wrong impellar?

    Looks good to me.----Take the impeller out.----If new the vanes will go straight.----And that water shooting out is normal.----A 60 / 70 HP model #is ?
  20. R

    1972 9.5 trouble reinstalling lower unit

    ??---Neutral , forward or reverse does not matter.--I hope I am clear with that statement.----SIMPLE----The notches on the upper and lower shift rod must line up with hole in connecter BEFORE you put the bolts in.----Move shift rods to give you the maximum room to work.
Top