Search results

  1. R

    1981 mercury tower of power 115

    Well----One close-up picture does not help YOU very much.----Post a few more pictures from a bit further away.----Sorry,---no mind readers here.
  2. R

    35HP Evinrude carb setting.

    Sorry----There is absolutely no reason for 2 stroke in good condition to stall !!----I would do a compression test first for trouble shooting and future reference.----Post your numbers.
  3. R

    Near new old 1996 Mercury 115

    Just needs one buyer.
  4. R

    1999 90 hp 3 cylinder 2 stroke mercury no power, sounds fine

    Report the results after you do the fuel pump and carburetors.----Or maybe there are some seagull feathers stuck in a reed valve.
  5. R

    Winner manufacturer and parts

    Made in the USA I believe.----Many of the " Winner " boats do not use wood in the stringers.----They did use plywood in the transom.----Replaced a transom on one ( wildcat 18' ? ) about 12 /15 years ago.----I worked at a dealer one time that sold a few in the mid 1970's.
  6. R

    1973 18 hp evinrude Driver Coil test

    Throttle position DOES NOT matter when setting points with a meter.
  7. R

    What year outboard is this Super Seahorse 40hp?

    The simple carburetor and the float and float valve need attention.
  8. R

    Johnson 150 Rebuild/Remanufacture Guidance

    Sometimes a different connecter / wire changes the part #.----A good dealer would know how to help you here.
  9. R

    88 Johnson 25 won’t rev

    Sorry ---I looked at post #1 about a 1988 model 25 HP.
  10. R

    Johnson 150 Rebuild/Remanufacture Guidance

    Your location.-----E-bay ----amazon----evinrudeparts.ca-----Just a few possibilities.
  11. R

    Changed Thermostat and Impeller, but...

    Looks like you need to replace / refinish pump housing.----Water does NOT stream out those 2 holes at idle.----It just mists out of them.
  12. R

    88 Johnson 25 won’t rev

    I do not believe there is a high speed needle on a 1988 model 25 HP carburetor.
  13. R

    Near new old 1996 Mercury 115

    In some areas folks are paying $100,000 over asking price for houses in small towns.-----So what is wrong with asking $5000 for a reported " near new condition " item like an outboard motor !!
  14. R

    Finally Had To Retire It

    I would say the engine is the 4 cylinder model 650 last marketed in 1971 rated at 65 HP.
  15. R

    RPM drops on 2hp 1977 Evinrude

    Possible filter screen is partially plugged on tank valve assembly.----Pull the flywheel and inspect the magneto.----Possibly a cracked coil.
  16. R

    Near new old 1996 Mercury 115

    List it for $5000 or more .----Lots of buyers out there today.----Good " used " motors are scarce in some areas.-----Take pictures of it and put it on craiglist / facebook / local bulletin board.
  17. R

    Mercury 110 9.8 no-start

    Tested for spark that will jump a gap of 5/16" ( 8 mm ) or better ?
  18. R

    1962' 50529A Starflite IV Magneto Ignition Weak Spark

    Good work.----No parts needed I assume.----Some of this stuff ( magneto ) here is simpler and more reliable than miniature electronics on new motors.
  19. R

    1978 evinrude 150

    What do you mean by ----" cables didn't seem to work "----Did not move correctly or maybe a simple clip missing to hold them on the linkages ?
  20. R

    1973 18 hp evinrude Driver Coil test

    Clean points with some 320 emery paper.----Then clean with alcohol.-----Test run.
Top