Search results

  1. R

    No spark

    Did you take the starter apart ?----Did you take an OHM reading from commutator to shaft ( should read infinity ) ?----Did you install new brushes ?----Sorry I can NOT SEE what you mean by " checked starter " from where I sit.
  2. R

    No spark

    Most folks will argue when I present the following no money spent instructions.------Load test your battery even if new.----Take starter apart for inspection and OHM check of commutator to shaft.---Inspect / test battery cables.-----REASON----If motor does not turn fast enough there will be no...
  3. R

    1988 mariner 135 marathon idle/ starting issues

    With 112 PSI compression I would remove that cylinder head.----In the big picture a head gasket is cheap.-----You will learn a lot by looking at the cylinder walls.---Spark but " not running " then I would check the flywheel key.
  4. R

    Intake manifold 1980

    No difference.----Same part numbers.
  5. R

    Johnson 55 hp throttle won't advance while in gear.

    You do realize that the one lever is for warmup only !----Moving the big lever first shifts it.---Then as you move that further the speed increases.----And you should not be putting this motor in gear if motor is not running.----Or when it is not running the propeller MUST be turned in order to...
  6. R

    Should I purchase a 60HP 1969 Johnson hydro-electric shift outboard motor?

    They are quite simple.------Very few complaints like on other motors with shift cables not adjusted properly.
  7. R

    going to the dark side - repower

    The 48 SPL is a very good motor.----One issue is the less than robust lower unit on them.-----Use the best gear oil in it and make sure seals keep the water out of it.
  8. R

    Johnson 55 hp throttle won't advance while in gear.

    Best to have a look inside the throttle / shift control box.----From where I sit there appears to be an issue with the interlock mechanism.
  9. R

    1998 90HP Evinrude Problems!

    +++++ on the above.-----Folks have little knowledge of how these parts fit and work I think.
  10. R

    Cooling water output J150EXECD

    Each carburetor feeds one cylinder.-----Much the same as most outboard motors !-----A blocked carburetor means LESS oil going into 1 cylinder and that is not good.
  11. R

    Trouble shooting these old Mercs

    Well------What year is an ----" old merc "------Is it a 1961 or a 1995 model ?
  12. R

    1958 SCOTT 60 HP FUEL PUMP

    Post pictures of the pages in your parts book.----I doubt there is a pump in the junction box.-----Most fuel pumps on those operate with crankcase compression pulses.-----You should be able to adapt many different pumps from Johnson / Mercury / Suzuki / Yamaha to that motor.
  13. R

    Johnson 55 hp throttle won't advance while in gear.

    Sorry----I can not see the linkages on your motor on my screen.
  14. R

    Johnson 55 hp throttle won't advance while in gear.

    Model # is ??----Is this still a tiller operated motor ?
  15. R

    suzuki df60 gearbox,/lower unit extension

    See if -----bay manufacturing------Offers a kit for your motor.
  16. R

    1990ish Evinrude 6hp not idling

    Replace the wee tube.--Factory material is best.-----Make sure it does not interfere with the float.----Test run.
  17. R

    1990ish Evinrude 6hp not idling

    That damaged tube explains the poor idling !
  18. R

    When do you replace the fuel filter?

    Just install a new one.
  19. R

    When do you replace the fuel filter?

    I do not believe the filter in the picture is the sintered metal one.
  20. R

    Mercury 9.9 propshaft removal from bearing carrier

    That thrust hub may be splined.----When turned around that becomes the tool to remove the bearing carrier.-----Time to cut the propshaft or thrust washer to get this apart !!!
Top