Thank you and will do. Inclined to think it's a coil pack for that cylinder. Appreciate detailing where it is. I'm also going to do a compression test just to see where the motor is at. Its It's been great for the 10years I've owned it
Hello all,
This s a 4 cylinder motor w/ 2 carbs. When I winterized the motor, the plug on the bottom cylinder was like new. The motor seemed sluggish the few times I could use it last summer. 15' boat would normally jump out of the water.
Where should I start?
Thank you
Hi everyone, been a little while since my last post, good to be here. I have a small tear on a vinyl cushion in the bow.
What's the Best or at least a very good repair kit to buy?
Ty, Dave
Not sure where to post this question.
Is it worth while to keep my battery on a trickle charge? I usually put it on a charger a few weeks before the season.
Gentleman, I've been posting about my fuel gauge not working. After two new sending units with no change, I bought a new gauge.
Good news: The gauge has a reading
Bad news: It's reading half full no matter how much fuel is in the tank
Could this be a ground wire issue?
I'm...
Hi, not sure what else to do? I have a '95 Capri, 1700 LS. Nice boat for what I do and runs great. Owned for 4 years, my 3rd boat.
The fuel gauge does not work. I installed a new sending unit last year and that didn't fix it. I just purchased a new gauge which I'll install this week.
Q...
Good morning gentleman,
Near the end of my trip last week to one of our lakes, the starter got stuck and would not engage the flywheel. I used a screwdriver and the starter shaft popped up and engaged. I noticed the shaft was very very dry. Once I shut the motor down the shaft got stuck again...
Not sure if this is the right place for this thread... ?
Bayliner Capri LS1700, 20 gallon tank. Want to buy the correct size sending unit. WEMA SSS6 (6" length) is what I think it needs but not sure.
Any help is appreciated or what to measure?
Thank you, Dave
Not sure how to describe this:
My gas gauge does not work but told by the original owner that it's the sending unit that sits on top of the gas tank. 20 gal tank is under the floor back by the bilge area. Sorry no picture and boat covered and stored for winter.
Can anyone help me with this...
I remember reading this some years ago and tried it for a couple winters on my 85hp. Didn't seem to bother it.
Would anyone recommend this or Not do this?
Thx Dave
The motor creeps down when tilted up, mostly when stopped and at full tilt up. Everything works well and this seems to be the only issue, like a small leak somewhere in the system. Can someone give me some possibilities as to the problem?
TY, Dave
I need to replace the plastic bracket under the driver's side back seat section of the seat. This seat, front and back pull out to form a bench or sleeping seat. I'm sure many of you know what I mean. I tried uploading a better closer picture of the problem but it didn't seem to want to upload...
Hey guys, I read here a few years ago that spraying a light glaze of WD40 over the motor was a good idea for winterizing.
Is that true, or, does it help?
I guess it can't hurt but wanted to hear from the community.
Thx Dave
