Search results

  1. L

    low compression #2 cylinder - 1988 suzuki dt85

    First of all, ALL outboards have steel sleeves, as do all aluminum engine blocks. Because of the design of the blocks, most cannot be re-sleeved. Why would you disable a proven, well designed oil injection system when the engine overheated? Lastly, as I stated above, pistons have long been...
  2. L

    low compression #2 cylinder - 1988 suzuki dt85

    Pistons discontinued.
  3. L

    Cannot use trim assist 2022 yamaha

    So all you had to do was call the dealer? Interesting.....
  4. L

    Cannot use trim assist 2022 yamaha

    Here's a novel idea - since it's a new engine, why not ask your installing dealer why it does not work?
  5. L

    2008 DF90 won't start.

    The reason I asked about the location is early on we had some that were installed inside the engine cowling with the network backbone starting there and we were getting some RF interference that was causing symptoms similar to your initial issue, but never complete shutdown. Nowhere in the...
  6. L

    2008 DF90 won't start.

    You are headed in the wrong direction. Study the service manual and wiring diagram closely to learn how the system & gray wire circuit works, and where the problem may be. As far as the interface, you would have had to disconnect it in order to use the diagnostic program. Where is the...
  7. L

    2008 DF90 won't start.

    Unbelievable. What does low voltage at the injectors indicate? LOW VOLTAGE IN THE GRAY WIRE CIRCUIT!! It does not indicate a bad ECM, relay or fuse. You're not filling my ego. 99yam40 and I have both told that. I do not have the engine here, so I cannot find the weak spot for you. Just...
  8. L

    2008 DF90 won't start.

    You can keep wasting your money and throw parts at it, or believe & follow the troubleshooting. Why did you replace the relays?
  9. L

    2008 DF90 won't start.

    Look at the chart - where does insufficient injector voltage lead you?
  10. L

    2008 DF90 won't start.

    It's right in your original post - re-read and follow the troubleshooting chart.
  11. L

    2008 DF90 won't start.

    The results you provide, if done properly, do NOT lead to a bad ECM. I suggest you read the troubleshooting chart more closely.
  12. L

    2008 DF90 won't start.

    I assume you have the $330 Suzuki 44 pin test harness?
  13. L

    Yamaha F100 TLRY - 2 lower units but only one shaft fits?

    Remove spark plugs, rotate flywheel while inserting drive shaft until lower splines line up with oil pump drive.
  14. L

    Suzuki DF9.9BT - System Monitor Gauge not Working

    Contrary to popular belief, not all Suzuki engines are the same.
  15. L

    Any lower unit experts?

    Did you change the gear oil after 20 hours of use? How much gear oil did you drain out prior to disassembly?
  16. L

    Any lower unit experts?

    Was this on a new engine, or was just the lower unit replaced? If so, why? How many hours?
  17. L

    Suzuki DF9.9BT - System Monitor Gauge not Working

    Who told you that the 9.9B provides that function? Did you ask your dealer prior to shelling out all that money (twice?)?
  18. L

    Suzuki DF115A throttle position sensor voltage

    Instead of cheaping out and getting free, incorrect info (no CTP switch on that engine) on the internet, purchase the correct service manual for your engine, purchase the $320 test cord and then realize that the TPS is not adjustable. It is factory preset. If out of specs, replace.
  19. L

    2001 Suzuki 4 Stroke Controls

    Have you even tried your local dealer?
  20. L

    2001 Suzuki 4 Stroke Controls

    Have you "looked" at your local Suzuki dealer? All the components you need are readily available.
Top