Search results

  1. D

    Old Merc Starter

    I am looking for a starter on a 60is 20hp merc. I remember reading once someone said that same starter is on a PWC motor but I cannot remember which one. Any help I just need one.
  2. D

    Primer/Sealer or not

    I am restoring a 78 MonArk. I am to the point of paint. This is my seventh complete restoration and I have always sealed the old paint on the fiberglass but just because the paint store told me to. I was wondering if it is original do I have to seal it. I always apply base coat clear coat...
  3. D

    Chrome and Rust

    Any suggestions on rusty chrome trailer rims. The rust in rather bad and I think the plastic hubs look bad. I really dont want to spend the money to get them blasted but would like to get the rims to hold paint.
  4. D

    1992 Merc 200 Trim

    This trim has me stumped. The other day the motor stopped triming up when you were going. The motor will only trim about half the way but it you slow down to around 2500-3000 rpms it will go ahead and trim up like normal. It will also trim like normal at ideal. Any ideas. No leaks around...
  5. D

    1998 Rude 175 Ram

    Does anybody know what the RPMS should be on a 1998 175 Ram at WOT
  6. D

    1968 Merc 200 Frozen

    I have a 1968 Merc 200. I got the motor running well but never realized it would not turn, it is froze up pretty good. Wont take any grease at all. I have pulled the cert and it is really gummed up in there. Can anyone tell me how to fix this without having to pull the powerhead. I think if...
  7. D

    Merc Carb with PIC

    Can anyone tell me what year range this carb is The float on the right is the one they say replaces the bad one on the left. It is obvious they are different. Anyone help with a part number on the bad float.
  8. D

    Carb Float

    Need help with motor or carb year(s) carb part number is 1374-5427. Serial numbers do not match powerhead. Frost plug on powerhead is gone. Have no clue what year motor is and think it is a 200hp. I just need a part number for a float.
  9. D

    Mariner Powerhead Swap

    Using the serial number on the motor it tells me it is a 1991 Mariner Magnum 111 2.5lt 150hp. I ordered some head gaskets and they did not fit. I think the powerhead was swapped out on this thing. If I us Mercury's Website I can search the old head gasket part number and located it but it...
  10. D

    1991 Mariner 150hp Head Question

    What is the torque on the head bolts.
  11. D

    Another Year Question

    Mariner Serial Number OD155410 Model Number 7150453AD And If anybody knows what is the torque on the head.
  12. D

    suzuki 1994 2 stroke 115hp

    This thing has me stumped. I know it is a fuel problem. It runs great for a short distance then stops. The primer bulb goes soft. So I put a new fuel pump kit in it and figured it would fix it. Well I was wrong. I put a new primer bulb still same problem. Then I by passed all the fitting...
  13. D

    Suzuki Throttle Postion Sensor

    Can someone tell me what it does other than effect the ideal. Is it also the timing advance and if not how do you change the timing on these suzukis.
  14. D

    65 Suzuki

    1996 Suzuki -- Rebuilt that carbs, new fuel lines, and new fuel pump kit. I can get the motor to run a bit if I play with the choke while it is going. It will also just fire off and get up right from the start but will go back to sluggish after a few seconds at WOT. I noticed it is spitting...
  15. D

    Suzuki Power Head Swap

    Will a 94 115hp power head fit on a 89 lower half 115hp.
  16. D

    Fuel Pump ?

    Suzuki 65hp 1986 Here is the problem I cleaned the carbs twice now. When you first start it it will take off great but cuts out. After it cuts out you can get a little more out of it by playing with the choke but not much still slugish. After you play with the choke the primer bulb will leak...
  17. D

    Fuel pump

    Here is the problem I cleaned the carbs twice now. When you first start it it will take off great but cuts out. After it cuts out you can get a little more out of it by playing with the choke but not much still slugish. After you play with the choke the primer bulb will leak down. If you...
  18. D

    Carb Cleaner Tips

    I was wondering what everyone is using for Carb cleaning. I normally use Berimans carb dip and let them soak works great on all others. I have found the suzuki carbs have that white stuff in them often. This may just be because I normally dont see salt water motors but it seems the metal on the...
  19. D

    Suzuki Carbs

    I was wondering what everyone is using on the Suzuki Carbs for cleaning. I normally use Berimans carb dip and let them soak works great on all others. I have found the suzuki carbs have that white stuff in them often. This may just be because I normally dont see salt water motors but it seems...
  20. D

    1986 Dt65

    Motor set awhile and I rebuild carbs, new plugs, decarb, and water pump. When you first start the motor it will run great and get up on plane fast then you get a quick beep then it goes to safe mode. I think it is a oil problem. Oil tank is full of new oil but was wondering what is the most...
Top