Search results

  1. flyingscott

    1986 Johnson 150 HP Crossflow V6 Rebuild - Now What?

    run a decarb in your fuel. WSM is a factory style piston
  2. flyingscott

    I’m at a loss - Evinrude 40

    I will call BS on that kind of speed on that old of a 40 hp.
  3. flyingscott

    '23 Merc 15hp EFI alarm

    Aren't they under warranty?
  4. flyingscott

    1986 Johnson 150 HP Crossflow V6 Rebuild - Now What?

    If you put in factory pistons run a decarb in your gas. Use quality oil and make sure the thermostats are working.
  5. flyingscott

    1993 evenrude 70 hp compression

    When the head comes off you can see it. It will be on the piston either a part# and or size. May need to clean the pistons off to see it
  6. flyingscott

    1993 evenrude 70 hp compression

    Check the piston size before anything.
  7. flyingscott

    1993 evenrude 70 hp compression

    get a different compression tester and try again
  8. flyingscott

    1993 evenrude 70 hp compression

    that's pretty common for the middle cylinder to be damaged on those. There was a service bulletin for the peehole to be re located to the top of the block to prevent that. Is that Done? try a different gauge, or pull the head off
  9. flyingscott

    1995 25hp Johnson 2 stroke, what are the best years for the 25 hp?

    anything just not a 3 cylinder.
  10. flyingscott

    1989 25hp Evinrude compression release

    Does that have a recoil starter on it. Those motors are pretty stout to pull. Check all your electrical connections. Make sure they are shiny clean the grounds on the block also.
  11. flyingscott

    looking for advice on a 1996 merc 15 hp.

    buy a different motor. Converting it to a tiller is going to be expensive by itself. Then you have the lower unit problem which is a known issue on those motors.
  12. flyingscott

    1991 Mariner 115 4 Cylinder 2+2 Compression

    How does it run?
  13. flyingscott

    40hp '67 super seahorse top speed.

    Your speed is where I would expect it to be.
  14. flyingscott

    1995 Mercury 2+2 Help needed

    Have you Looked at the fuel pump diaphragm? The accelerator pumps and or primer.
  15. flyingscott

    Sea foam for outboards?

    With that motor use a carbon guard or Yamaha ring free.
  16. flyingscott

    I’m at a loss - Evinrude 40

    Ken Cook publishing. Only a factory manual is worth buying. No Seloc or Clymer https://www.outboardbooks.com/
  17. flyingscott

    I’m at a loss - Evinrude 40

    Get a manual. Have you dine a link and sync?
  18. flyingscott

    89 Johnson 60 HP VRO No Start

    Your compression is horrible. Is your starter spinning fast enough? Where did you buy the CDI box from? Do you have a factory manual?
  19. flyingscott

    1982 15 hp Evinrude pops out of gear when slowing down

    Did the shift shaft get spun out during any of these impeller changes? Brass coupler not seated correctly?
  20. flyingscott

    97 Mercury 150HP v6 lower end unit

    I am going to say no because I bet the gear ratio is different. Look at an SEI unit
Top