Search results

  1. N

    Mercruiser Pre Alpha trim senders wiring schematic

    I am rebuilding my trim senders limit and position. I do not know where to hook up the wires once you pull them through the transom. I have the manual but it doesn't say anything about the wiring. Please advise.
  2. N

    Rochester 2 jets carb dies when shift into gear or throttle

    Please advise how to troubleshoot.
  3. N

    1984 Mercruiser Bravo makes grinding noise when shift into forward or reverse

    1984 Mercruiser Bravo makes grinding noise when shift into forward or reverse. Please advise how to troubleshoot
  4. N

    AQ270 Mechanical Lift Just "clicks" When Swith Is Pushed To Lower Or Raise The Drive

    AQ270 Mechanical Lift Just "clicks" When Swith Is Pushed To Lower Or Raise The Drive When I push the swith to lower or raise the drive it just makes a clicking noise. It did this before and I was able to wiggle the box where the relay switches are located to make it work. Could it be a...
  5. N

    AQ125A iddles cool at 140 but overheats at high speed or RPM

    AQ125A iddles cool at 140 but overheats at high speed or RPM. I have replaced the following: water pump rebuild, water strainer housing, and the piece that connects the hose to the 270 outdrive. When I hooked up the muffs to it and run it at iddle speed it runs at 140 degrees all day long w/...
  6. N

    AQ125A w/ 270 outdrive makes noises when the steering wheel is turn all the way.

    How to troubleshoot my 270 outdrive when I steer all the ways to the right or left it makes noises.
  7. N

    Volvo Penta AQ125A w/ 270 out drive will not unlock automatically to trim motor up

    My Volvo Penta AQ125A w/270 outdrive lock mechanism will not unlock automatically. The power trim still works. It just doesn't unlock by itself when I trim the motor up. How do I troubleshoot?
  8. N

    What is the propeller size for AQ125A 4 cyl., 19 ft boat should I buy?

    What is the propeller size for AQ125A 4 cyl., 19 ft boat at sea level with Max RPM 4400-4800 and Max Cruise RPM 4300-4500? From prior post I guess it should be 14x19 or 14x17?
  9. N

    Volvo Penta 270 outdrive lock mechanisim will not release when trimming motor up.

    Volvo Penta 270 outdrive lock mechanisim will not release when trimming motor up. I have to manually unlock it. Trim motor works.
  10. N

    How to replace AQ125A raw water pump sealing ring #12

    I am trying to replace the AQ125A raw water pump sealing ring #12 and have a couple of question. The seal has a front and a back side, which way does the seal go in? Is there a trick to getting the seal in without pounding it with a rubber mallet? Thanks.
  11. N

    1983 Volvo Penta AQ125A carburetor float bowl does not get refilled at the right leve

    1983 Volvo Penta AQ125A carburetor problem. I rebuild the carb. Filled the float bowl with fresh gas. It starsts right up, idles smoothly, and runs for about the time the float bowl gets emptied (10min). When the bowl is empty the motor shuts off and will not start again. I have to take the...
  12. N

    What Marinized Auto Engine from Volvo can I swap parts for a 1983 Volvo Penta AQ125A?

    What Marinized Auto Engine from Volvo can I swap parts for a 1983 Volvo Penta AQ125A? I heard you can use parts from a same year Volvo 244 DL. Pleased confirm or advise what the 1983 Volvo Penta AQ125A is compatible with.
  13. N

    '83 Volvo Penta AQ125A compatible to '83 Volvo 244 DL? Ignition parts needed

    Is '83 Volvo Penta AQ125A compatible to '83 Volvo 244 DL? I need to replace ignition parts: rotor cap rotor ignition wire/set spark plugs I don't want to buy from Volvo Penta Marine. Please advise.
  14. N

    Volvo Penta AQ125A w/ 270 Outdrive- Water Strainer Cap Squirts out Water

    Water keeps on squirting out of the raw water strainer cap immediately after the motor is started. Do I need to replace the raw water strainer cap or is it building up pressure due to clog in the exhaust system. There is water that spits out at the exhaust end of the lower unit so I am...
  15. N

    1964 Johnson 75 Electric shift dies when place in forward or reverse

    1964 Johnson 75 Electric shift dies when place in forward or reverse. Don't know if it's the "low idle speed adjustment" that needs adjusting or the wiring or something else. I do have the manual but do not know what the problem is. Don't want to take apart the lower unit until I know what...
  16. N

    1966 Johnson 100 HP starter # 378228

    Does anybody know where i can get a replacement starter for a 1966 Johnson 100 HP starter w/ part # 378228? EDIT
  17. N

    1966 Johnson 100 HP Meteor Starter

    Where can one find a replacement starter for 1966 Johnson 100 HP Meteor. Is it Meteor or Golden Meteor? Regards, Nic
View older results
Top