Search results

  1. alldodge

    Proper Carburetor adjustment

  2. alldodge

    New valve cover gaskets and still leaking V6 4.3

    No problem reusing the bolts forever.
  3. alldodge

    Ran amazing then shake no thrust

    Lot of corrosion but is normal for them to get that way. Every couple years of so, need to remove and clean contacts
  4. alldodge

    2008 Mercruiser 5.0 tks won't go into drive or reverse

    Exploded views and parts https://www.mercruiserparts.com/remote-controls-and-components
  5. alldodge

    Mercruiser Thunderbolt V Ignition No Longer Available

    Being intermittent, not so sure its bad. Electronics dn't work and stop, then start again If your sure its gone, then I would go to Delco EST
  6. alldodge

    Engine stops after a few hours use

    When it dies, open the gas cap and listen to see if you hear air suck in. If that's what happens, its the tank vent line
  7. alldodge

    Broval 1 outdrive won’t go down, no noise from trim pump

    Most likely the trim switch in the handle is not working or the wire connecting the switch to the relay. The Green/White wire is what to check
  8. alldodge

    New valve cover gaskets and still leaking V6 4.3

    I thought the gasket couldn't be seen once installed. Never had a V6 so @Bondo @Scott Danforth @kenny nunez
  9. alldodge

    2008 Mercruiser 5.0 tks won't go into drive or reverse

    Did the throttle only button get stuck ingaged?
  10. alldodge

    New valve cover gaskets and still leaking V6 4.3

    Don't see an issue with the oil vapor, all motors do it and the older they get the more it does it
  11. alldodge

    Start

    Then your Bat is bad, the cables and or connections are corroded, or the starter needs replacing.. Have the Bat load tested at local auto parts place
  12. alldodge

    Start

    I don't put a lot of faith in a boats Bat gauge, but your Bat is about dead, can tell that just from the sound of it cranking Get the Bat charge up and try again
  13. alldodge

    Start

    Sometimes the Tach can short out so its good practice if there is no spark to disconnect the wire. This didn't help at this time, but we still don't know if its no spark or fuel. Were going down testing for spark first
  14. alldodge

    Start

    SN and your pic shows TB5 ignition with knock module Run thru this troubleshooting guide "exactly" like it says
  15. alldodge

    12volt not working

    They are breakers and can be reset with Bat ON or OFF, doesn't matter
  16. alldodge

    Cooked my impeller

    Should be 46-96148A8
  17. alldodge

    Thermostat location on 2020 Volvo Penta 4.3L V6 280HP I/O Forward Drive

    Might be able to find it using your serial number at volvopentashop.com
  18. alldodge

    New to me Colbalt, Overheating only while pulling tube or ski

    No special tools needed, remove the six nuts and pull the drive I only mention to remove the drive because it will make it easier to replace parts with the drive being out. You might be able to replace the part without removing the drive. Raise full up and see if there is room I don't know...
  19. alldodge

    New to me Colbalt, Overheating only while pulling tube or ski

    Can get yo that part after removing drive
  20. alldodge

    Any way to reset an mpi without rinda tool

    Don't know how to do with 555 other then diacom or techmate
Top