Search results

  1. Scott Danforth

    7.5 Mercury Issues

    You need the venturi tube You also have dirt in the carb
  2. Scott Danforth

    Bravo 3 with small leak from prop shaft

    I would reseal the drive
  3. Scott Danforth

    Pontoons - Growth from being slipped...what is it?

    High mineral content. its basically hard water deposits.
  4. Scott Danforth

    Re-upholstery Job on Cruisers Yacht 338 Bowrider

    and to let the seat breath when water gets on it and soaks thru the stitching
  5. Scott Danforth

    Bought a new long block and wondering about the coupling and gimbal bearing.

    use the grey RTV for waterpumps
  6. Scott Danforth

    Gelcoating keel

    if you have a fiberglass supply house near you. start there.
  7. Scott Danforth

    Re-upholstery Job on Cruisers Yacht 338 Bowrider

    If it doesnt work out, repattern until it does
  8. Scott Danforth

    6.2 vortec head torque setting?

    If you over-torqued them, did you damage the block threads or the bolts? Bolt torque is listed as 65 ft-lb for an SBC. The extra 10 lb-ft should not be an issue, however not guaranteed.
  9. Scott Danforth

    Gelcoating keel

    You will need to scuff the area, then roll on the gel. I would suggest a keel guard if you intend to beach
  10. Scott Danforth

    Mercruiser 3.0 = Chevy 181 CID = Small Block Chevy Valve Train? 1:65 Rockers?

    I would beg to differ. Remove a thermostat and see how badly a system cools. Thermal transfer requires a specific time for water to pick up heat. That time is controlled by velocity.
  11. Scott Danforth

    Tracing the trim problem

    There should be 5 manuals. One for base engine, one for the drive, one for the EVC which is what you need for the trim system reset, etc, one for the fuel system (efi) and one for controls I believe the drive manual is 7746477
  12. Scott Danforth

    6.2 vortec head torque setting?

    The torque setting depend solely on which fasteners you bought
  13. Scott Danforth

    Restoring my boat

    Either christmas tree fasteners or z-clips
  14. Scott Danforth

    opinions: best way to replace swivel shaft and gimbal ring on bravo

    Pull the motor
  15. Scott Danforth

    Tracing the trim problem

    You have a factory Volvo Penta manual, or a haynes or clymer or seloc ?
  16. Scott Danforth

    aquasport 175 osprey

    Thieves dont care about special colors, if they can steal something, they will
  17. Scott Danforth

    Rustoleum Paint Question

    If you spray it, you can recoat 3 times within 2 hours
  18. Scott Danforth

    Need help IDing my first boat

    What does the paperwork say it is?
  19. Scott Danforth

    Tracing the trim problem

    The factory manual has a whole section on testing the trim system
  20. Scott Danforth

    Bought a new long block and wondering about the coupling and gimbal bearing.

    you can just shove a hose up the hole in the gimbal housing to run it.
Top