Search results

  1. alldodge

    Transducer location for mercruiser outboard boat (pic included)

    Welcome, it should not be close to the drive so it won't get any prop wash which would interfere with it. Hey got another for you @dingbat
  2. alldodge

    No fuel at rail with KO/EO merc 350 mag mpi tow sport (02 centurion)

    Welcome What is your motor serial number? You could have 1 or 2 pumps, just depends on what the motor configuration is and the serial number will verify. Yes, you should get 43 psi at the rail
  3. alldodge

    200 verado won’t run above 4500 RPM

    Need someone like @muc but have you watched that the throttle is moving to 100% WOT? Don't know which scanner your using, but need to see if motor says your getting 100% power, and Guardian is staying below 100%
  4. alldodge

    2011 seadoo gtx 260 limited no power

    Don't know but suggest post on Green Hulk, lot more knowledge there
  5. alldodge

    Trolling motor disrupts sonar image

    Guessing, but trolling motor on the bow means it's stirring up the water, and making bubbles. Sonar can not read thru bubbles nor can a depth finder. But will see if @dingbat knows better
  6. alldodge

    Spark plugs

    Moved you to VP, because it's a motor question not a 4 winns
  7. alldodge

    Mercruiser 5.0 MPI idling problem

    Correct, appears to be working, So long as switch does same when running (nola mike) Not seeing signs of vacuum leak. Motor goes under heavier load (idle in gear) and idle smooths out. Going into gear would cause the IAC to open more do to load Be nice if scanner was connected to watch what...
  8. alldodge

    Mercruiser 5.0 MPI idling problem

    Not complete cut off
  9. alldodge

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    IS your cooling system like this one, or is it different?
  10. alldodge

    Mercruiser 5.0 MPI idling problem

    It does fine in-gear and rough in neutral As nola mike mentioned it's the shift interrupter. The switch is staying engaged and causes the rough idle. Might need adjusted, lubricate linkage or replaced
  11. alldodge

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    What is your serial number and are you open or closed cool?
  12. alldodge

    No fuel in carb despite several attempts to crank

    Your right, I forget that Mod's can see deleted threads. I need to update my sig
  13. alldodge

    Mercruiser 5.7mpi horizon single cylinder burning lean

    Yes it checks out No not bad at all for me :) for you yes, I'm sorry :cry:
  14. alldodge

    150hp xr2 ignition switch

    This is standard wiring for 2 cycle WIRING
  15. alldodge

    Mercruiser 5.7mpi horizon single cylinder burning lean

    Yes, correct my bad, i'll fix
  16. alldodge

    Hydraulic Steering for Sterndrive

    I would suggest seastar
  17. alldodge

    Mercruiser 5.7mpi horizon single cylinder burning lean

    Your motor should have a MEFI-3 ECM (SN needed to verify) and it uses batch firing of the injectors. Batch firing means 4 injectors are fired at one time and normally fire at least twice for each revolution. Injector 2 and 4 are fired at the same time by the ECM. Swap 2 and 4 connectors to see...
  18. alldodge

    No fuel in carb despite several attempts to crank

    Might just have been a hiccup, it's working for me. Select the one in my sig and should take you there
  19. alldodge

    Mercruiser 3.0 wants to die only at 1800 RPM

    Sounds like the power valve. The power valve transitions the idle circuit to the main. Only way to fix it is get into the carb. Could replace the TKS with a standard carb
  20. alldodge

    No fuel in carb despite several attempts to crank

    After sitting that long it's not a tank vacuum Use a gas can and length of fuel line. If it fires up and keeps running then it's the antisiphone valve or the tank pickup If that doesn't work then it's the pump
Top