Search results

  1. alldodge

    Questions regarding Water Temp Sensor / Engine Temperature - 350 Magnum 1995

    With Stat as in post 6 the large hose can be slightly warm to 180* while running. The cool raw water comes in from drive to port side Stat most front port. If Stat is closed then the circulating water pump just moves current water in the block, there is very little cool water going into block...
  2. alldodge

    2 beep then constant alarm Mercruiser 4.3 mpi

    It probably just needs to be adjusted. Don't know if you have Alpha or Bravo, but Alpha is easy, Bravo not so much If Alpha with motor OFF, move throttle forward about 1/2 and then 3/4 way. Note where the switch is and difference between idle. If Bravo, you have to do it with motor running...
  3. alldodge

    2 beep then constant alarm Mercruiser 4.3 mpi

    Agree, there is power loss "IF" the motor thinks the drive is not in gear ok that's good, but this was not part of my comment Because ECM needs those sensors to run. Thanks for SN you have a motor with CAT exhaust
  4. alldodge

    1998 Regal 1700 LSR

    Move you to OMC
  5. alldodge

    Mercruiser 496 HO 2007 overheating

    Need to replace the rear cover. Search for Merc pump housing and will be able to find the rear cover
  6. alldodge

    Early bravo 1 is toast , newer upper options?

    Being a 88 most likely the drive does not have the lube bottle (your term non oiler). If this is correct you have 2 issues 1 - Need to plug the lube bottle connection or adapt to be able to use one 2 - You cannot use the new uppers on your lower due to oil channel is different and will not connect
  7. alldodge

    2 beep then constant alarm Mercruiser 4.3 mpi

    Always post at least the year of the motor and serial numbers are best Reviewing previous post from 2023 I think yours is a 2015 motor?? I might be the in gear switch on the shift plate. If you have Bravo drives then there will be one switch, if they are Alpha then there are 2 switch's...
  8. alldodge

    Oil in outdrive but passed pressure test

    Welcome You have a leak just need to find out what seal. Pressurize and then rotate each shaft drive, prop and shift. One or all of the seals is leaking. Vacuum test is a good test but keep it no more then 5 psi
  9. alldodge

    Spun hub or lower unit problem?

    Sure sounds like the hub, don't think it's the cable
  10. alldodge

    1997 7.4L MPI IAC valve location and removal

    Maybe but really doubtful It's pretty tight in there and your only talking about one gasket if TB is not removed. IMO just remove the TB
  11. alldodge

    Standard US sending unit resistances

    I'll leave it and hope someone else comes in with info to help. I have never heard of 450 ohms
  12. alldodge

    The tachometer on my 98 2330 sport SE is not working right

    Start with cleaning the connections on gauge and check the gray wire on the coil In most cases it does just need to be replaced because the manufacture that made the gauge either no longer makes that one, or they are out of business. Find out who made the gauge and see if they can repair
  13. alldodge

    Cobra intermediate cable replacement

    Hey @Lou C or @kenny nunez
  14. alldodge

    Standard US sending unit resistances

    Yes, cold 240 and 33 hot
  15. alldodge

    Standard US sending unit resistances

    North American standard is 240 cold/empty and 33 hot/full
  16. alldodge

    Mercruiser 3.0 TKS - Hard to start when semi-cold

    Should not need to pump when hot/warm Could bench test the TKS Oh and I said it backwards above, retracted cold and extended hot (did edit and fix)
  17. alldodge

    Bravo 1 vs 3 gimbal housing ?

    Have not seen one like that before, and your going to need the missing screw hole Wonder if it's maybe for a ITS (Integrated Transom System)
  18. alldodge

    Starter crapped out today, I tapped it with a hammer then it worked.

    Trying to figure out what the question your asking. I merged 2 threads which went from does someone have a number for my starter (post 2) to doesn't matter I'm getting a starter (post 1)
  19. alldodge

    She just won't start easy nor stay running 4.3l

    Should have spark doing this test
  20. alldodge

    Starter crapped out today, I tapped it with a hammer then it worked.

    Then why post a thread? Have noticed you do have a new thread addiction
Top