Search results

  1. alldodge

    Perco battery switch install

    Wasn't disagreeing or figured you would know, just used your post to note to OP what should be there and sounds like he figured it out Great news
  2. alldodge

    Perco battery switch install

    Then it should be like this pic, Where is the wire that goes to the 50amp breaker?
  3. alldodge

    Perco battery switch install

    There is a misunderstanding in terms between us Your pic shows the slave relay, the starter solenoid is on top of the starter Lets start again clean What is your motor serial number, or at least year and type?
  4. alldodge

    Perco battery switch install

    Bat Pos terminal to No 1 of Bat switch. Common on Bat switch to starter solenoid
  5. alldodge

    Perco battery switch install

    Before
  6. alldodge

    Force 50 hp outboard won't start

    closed
  7. alldodge

    1995 Stingray 4.3L Mercruiser No Start

    Most boats don't have schematics, they use standard practice for wiring circuits. Don't know if Stingray uses additional feed from battery to helm, but they should.
  8. alldodge

    LiFePO Batteries ???

    @cyclops222 I'm going to recommend allow this thread to go forward as it was intended from the beginning. Providing input of what may or may not be true is not helping. Comments are welcome so long as they advise of real world testing/analysis. Ted is working hard to get this right and most...
  9. alldodge

    Perco battery switch install

    Your correct, thanks for the correction
  10. alldodge

    Volvo Penta 2002 ? Blown a Fuse, Now Non Start

    Yes, remote start on Red and Yel/Red
  11. alldodge

    Perco battery switch install

    Trim pump comes off start Bat at starter post because it's next to the motor Anchor windless comes off House Bat Blower comes from the helm and is powered from start Bat Aux power feed Bilge pump is connected either directly to the start Bat or from common terminal at Bat switch
  12. alldodge

    Perco battery switch install

    The Common post goes directly to the starter on the motor
  13. alldodge

    Mercruiser hose hanging from exterior transom components

    Speedometer tube, connects on the drive
  14. alldodge

    6.2 MPI Whine noise when revs

    Try this it's real easy, simple and only takes a few seconds Large flat tip screw drive and back out the top vent plug on starboard side of drive Back it out slowly until you can get some drive lube come out of the plug. The lube should be greenish and thick. Don't worry if a bit much comes...
  15. alldodge

    2011 Tahoe Mer 4.3 - engine miss firing

    Without the correct fuel pressure the engine will not run correctly. With very little or no pressure it won't run at all
  16. alldodge

    '88 5.7 inboard dies after running smooth, restarts after few minutes, smooth again

    All test are with Key ON Wht/Red only gets 12V with key ON
  17. alldodge

    LiFePO Batteries ???

    Invented in 1996 but your have a B&D tool that was originally came with a Lithium battery? Dewalt didn't start till 2011
  18. alldodge

    Engine wont turn, frozen

    ok, then it's the pivot on the motor 99yam40 has probably the best method Lots of PB Blaster or other
  19. alldodge

    new to me 97 ski sanger dlx 20 stringer movement near stern

    Loose stringer, .. If it was mine it would not see water until fixed If you do go out anyway, make sure everyone wears a life jacket full time
  20. alldodge

    '88 5.7 inboard dies after running smooth, restarts after few minutes, smooth again

    Might clean the connections The hard walled hose laying across the coil wires might cause some wear issues with the insulated terminals. I would remove the connections and see if they are clean and insulation is intact Wonder why there is hard wall hose there?
Top