Search results

  1. alldodge

    Maybe my turn for new boat time

    There looks to be about 10* between each notch. Would kind of like to move it out maybe 3*, moving it a one notch you can see what happens. Might only need about a extra 1/8 to 1/16 on top to work
  2. alldodge

    Maybe my turn for new boat time

    Appreciate that Bruce, might do that but thinking of trying a simple solution. They make plastic putty knives sort of things. I have a couple hanging on above the bench. Should be able to cut a piece out of it and make a shim (nothing to maybe 1/16) should do it
  3. alldodge

    Maybe my turn for new boat time

    Well it warmed up so I drilled holes and mounted the antenna mount. The issues are unable to get the antenna to be straight up, it's leaning slightly inward. It is maybe 2 inches from the hardtop so it will hit when running. If I move it one notch then it leans outward which is worst. Might...
  4. alldodge

    1996 Four Winns Sundowner with 5.0 Cobra engine and drive

    Don't know of a easy way to test, but if one is leaking then both should be rebuilt Not a OMC guy, but I just searched on "OMC cobra trim ram repair kit" and a few came up
  5. alldodge

    LiFePO Batteries ???

    7 group 31's is about 200 lbs. Hope they were not all on one side
  6. alldodge

    wet slip dry dock option

    Yes, don't see any will leave hull bone dry
  7. alldodge

    1999 Mercury 15hsp 2 stroke- No water ??

    Welcome The oil on the water would most likely it's flooding, check the carb settings or rebuild time No water, I would take the leg back off and get back into the pump
  8. alldodge

    wet slip dry dock option

    Welcome Bottom will never be completely dry
  9. alldodge

    Bought my first boat to cut, gut and rebuild from bow to stern, including engine. Killed my back and suffered the wrath of the fiberglass demons

    Prior Owner
  10. alldodge

    Can't remove 5.7 vertically.

    Might be able to make a lifting device to lift and then slide out. hook xxxxxxxxxxxx xx xx xxxxxxxxxxxxxxxxxxxxxxxx motor If there is not enough room when motor is lifted all the...
  11. alldodge

    Help to source Bravo 3 gimbal housing

    I'm finding all use same part number
  12. alldodge

    LiFePO Batteries ???

    Bats in parallel BMS has no effect if one shorts out
  13. alldodge

    LiFePO Batteries ???

    Your drawing does not show any fuses/breakers between Bats. So unless they are currently left out, you would need to be there with a wrench to stop it
  14. alldodge

    LiFePO Batteries ???

    You know better then I but, if one goes bad most likely you won't see it coming and it doesn't take long for one to take the other out
  15. alldodge

    1996 Four Winns Sundowner with 5.0 Cobra engine and drive

    No, run in/out with no issues Might have issues reattaching drive, but connect long side then push down until short side lines up Don't fully understand the comment, but in most cases it's not good to fix issues with everything back together
  16. alldodge

    1976 Starcraft Mariner 21' Layout Changes? (v2)

    Is it you can only reach 4000 rpm then it would be over propped which would lug the motor. If your just cruising at 4000 then this would not be an issue. I hardly ever go above 4000 and can go as high as 6000
  17. alldodge

    How to add fluid to a 150 Yamaha hydraulic steering?

    If you don't see the plug then see if it has a cover all around the back of the helm that may come off
  18. alldodge

    Evinrude 15hp 15804B 1978 Complete rebuild 3x over bore

    Look up lock wire Need thin wire to clean the channels out Nice looking motor
  19. alldodge

    Mercury ob 1995 40hp. Roll pin with Trigger assembly??

    Don't have a manual for your motor but have another which uses a trigger link rod. This rod is adjusted in/out to set timing. Motor is shut down each time to readjust. Maybe yours has something similar
  20. alldodge

    How to add fluid to a 150 Yamaha hydraulic steering?

    Welcome Is it a Yam specific steering system or something like seastar? What year is the boat? Normal is bleed/added at the HELM
Top