Search results

  1. Bondo

    Shift cable brass pinned to threads

    Done
  2. Bondo

    MC-1 Lower Housing Part ID...

    Ayuh,..... That's the shift spool, with the ssteel washer on top of it,.....
  3. Bondo

    No power to new Kenwood stereo reciever

    Ayuh,..... My guess is, the red wire powers the unit, 'n the yellow wire preserves the memory,......
  4. Bondo

    Dead rise question

    Ayuh,..... Less dead rise, a rougher ride,.....
  5. Bondo

    Cooling Hose Fit Problems

    Ayuh,..... The hose looks right, the P/S cooler is usually right up under behind the motor mount, where it's tough to get too,......
  6. Bondo

    Second Happiest Day . . .

    Congrats Ted,...... I remember when you were lookin' for that boat,.... ;)
  7. Bondo

    2004 Glastron GX205 w/ Volvo Penta 5.0 Overheating

    Ayuh,..... Welcome Aboard,....... I'd investigate the plumbing from the outdrive to the raw water pump,.... If there's a leak there, it'll be suckin' air while on-plane, 'n water when not on-plane,....
  8. Bondo

    engine stalls when shifting back on forth a lot

    Ayuh,...... Never slow shift an Alpha, 'n Yes, it could very well the the root cause of yer "problem",.....
  9. Bondo

    Tahoe deckboat sink fuse is blowing

    Ayuh,..... Welcome Aboard,..... It sounds like both the wire from the fuel tank sender, 'n yer pump are seein' a dead short to ground, so I'd try to find someplace those wires run near each other,.....
  10. Bondo

    1985 Chris Craft Scorpion 168 I/O

    Ayuh,..... Welcome Aboard,...... What motor,..??..??
  11. Bondo

    Carb Recommendations for 5.7L Vortec?

    It's pretty easy with a napa, or harbor freight tubin' bender,.....
  12. Bondo

    Impeller Badly Damaged...

    Ayuh,.... Before you put it back together, put yer garden hose into the t-stat end of the in-comin' water line, 'n let 'er rip,...... That'll flush out any debris that might cause later issues,.....
  13. Bondo

    Engine temp question

    Ayuh,..... How long ago was the impeller changed,..??
  14. Bondo

    Carb Recommendations for 5.7L Vortec?

    Ayuh,...... Donno whether Merc ran the Weber carb/ mechanical pump or not,.... I know there's Merc fuel lines available for the electrical pumps,.... A length of steel or cupernickle 3/8" brake line, a couple brake line fittings, a bender, 'n flarin' tool, 'n you can knock off a custom fuel...
  15. Bondo

    Electrical issues

    Ayuh,..... What Scott said,.... Especially the ground connections,....
  16. Bondo

    Mercruiser 454 Oil/PS Cooler Replacement Question - Loss Of Oil

    Ayuh,.... On the BBCs they're both in the same cooler/ housing,....
  17. Bondo

    Mercruiser 165 shift cable bellows

    Ayuh,...... Whenever I have to pull the gimbell housing, I replace All the rubber parts while it's apart,..... That should give ya 'bout 8 years of trouble free boatin', as those rubber parts rarely last longer than 8 years,.....
  18. Bondo

    Mercruiser 165 riser elbow plug

    Ayuh,..... I've taken those out with my air impact gun,..... For that one, I'd heat the plug red hot, 'n quench it with water,..... If it don't come right out, heat, 'n quench it again,...... til it does,.....
  19. Bondo

    Starter bolt size 3.0 ser#D704455

    Ayuh,..... Welcome Aboard,...... 3/8-16, but you can't use plain ole bolts,..... Buy a set of Chevy starter bolts, available at 'bout any auto parts store,.....
  20. Bondo

    Power Steering Fluid Change

    Ayuh,..... Best way I've found to do it, involves a helper,..... Pull the low pressure return line off the pump, 'n direct it into a catchcan,...... Have a couple qt.s of new oil, caps off, at the ready,... Have yer helper start the motor, at idle, 'n slowly turn the wheel, lock to...
Top