Search results

  1. 9

    F250BTUR Bad Rattle

    who hooked up the new digital controls? did this motor have that type of controls before the new ones? Looks like the video shows it goes into gear cleanly, and starts pushing the boat. if the clutch dogs were not engaging properly they would not hold at higher RPM. is it possible that the...
  2. 9

    What is shaft length, 20", 25" or 30"

    L = 20" S = 15" U = 30" X = 25" 1st X =25 last X means 1999
  3. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    time to find out
  4. 9

    F250BTUR Bad Rattle

    does not sound like lower unit problem to me, it goes into gear just fine. does it keep making that noise while idling along, or is it just some seconds after putting into gear ?
  5. 9

    2013 Yamaha 25hp 4 stroke running hot

    over heat should not shut off a motor. maybe if you let it overheat to the point it locked up it would. if you can get it to start on muffs with the cowling off you could see where water is coming from
  6. 9

    1997 Yamaha C40 2 stroke tilt unit repair kit.

    any Yamaha dealer or find an online place. boat.net is a place I have used before
  7. 9

    2018 Yamaha 25 hp. 4 stroke will not run at slightly above idle.

    boat, load, prop are all part of what a motor can do. are you sure you have the right prop for what you are using the motor for?
  8. 9

    F250 TXR RAN OUT OF FUEL, NOW CANT GET FUEL TO INJECTORS

    running that pump with no fuel in the VST probably smoked it. it uses the fuel to lube and cool the pump/motor. but you need to make sure the pump is getting voltage and the ECU is giving it a ground path
  9. 9

    1997 Yamaha C40 2 stroke tilt unit repair kit.

    there is no kit, you buy what parts you want or need
  10. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    I sure hope the drive shaft for that pump was removed also. with no oil running thru the pump and it is being driven still could be bad
  11. 9

    Carb-mounted choke solenoid

    it is a 32 year old motor, you may not find a new one
  12. 9

    Yamaha 15 mounted too high

    4 strokes are usually rated at a higher RPM than the 2 strokes is why I asked what the motor is 6K may be fine if it is a 4 stroke,
  13. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Yamaha mechanical fuel pumps use the pulse from one of the cylinder crankcases to operate the fuel pump. most are mounted on the side of crankcase, but this one is mounted on the bottom carb so I assume it is still ported to either the crankcase or the the reed chamber to get the pulses. if the...
  14. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    I am not sure what you are trying to say. are you saying that one fuel pump will flood all carbs? the other poster was talking about if the pump diaphragm leaks, it will flood #3 crankcase and not affect all 3. which is correct.
  15. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    no worse than metal tanks back in the day
  16. 9

    Yamaha 15 mounted too high

    is this a 4 stroke or a 2 stroke 15? seems not many post up the true motor's model # anymore so it is hard to tell
  17. 9

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Tank pressure should not flood a motor. I had an old metal tank before on a 35 hp Evinrude that the primer bulb blow up on when I stopped at my parents house and let it sit in the sun for a few hours, but it never flooded the motor
  18. 9

    Yamaha F60TLRH 2009 Model - Doesn’t Start on 1st Turn of Ignition

    I had thoughts in the past that the lift pump comes on when key is turned to the on position on these motors, but I was told different. Just the pump inside the Vst comes on pressurizing the rail. the lift pump only runs when the motor is running. I have no idea what motors that is true on, but...
  19. 9

    2009 Yamaha 15hp 2 stroke pull cord problem

    what does a bunch of blobby deposits mean? Have you pulled the spark plugs to look at them and what comes out of the plug hole if you spin the motor without the plugs in? You need to find out if water is getting into the combustion chamber , before worrying about what to do if it is. Could the...
  20. 9

    Yamaha F60TLRH 2009 Model - Doesn’t Start on 1st Turn of Ignition

    from what I have read about injected 4 stroke motors, the IAC resets to 100% when you turn off the motor so it will be ready for the next start up. when started it will be at high idle until the ECU tells the IAC to slow RPMs to normal idle speed maybe your IAC was sticking and not closing...
Top