Search results

  1. C

    9.9 evinrude wont idle

    exactly what I'll be checking
  2. C

    Evinrude E-Tech 90HO

    not your year but lots of info https://www.manualslib.com/products/Evinrude-E-Tec-90-Hp-3620854.html
  3. C

    9.9 evinrude wont idle

    may not be your issue but a recent case of a bad idle on a 9.5 ( VERY diff. carb design) it turns out that if the angle of the engine his changed it idles better. next week I'll take a look at the float adjustment to hopefully fix it . the engine starts well, runs well but won't...
  4. C

    9.9 evinrude wont idle

    spark ok ?? clean the carb again open up idle (top needle) a bit
  5. C

    Evinrude E-Tech 90HO

    1- you need the manual to service your engine tech lights are one thing there are four on the EMM you need to consult you should get yourself the diagnostic software to check fault codes or have a dealer plug in and give you a report after lights off on the tach that engine...
  6. C

    Low compression on 1967 9.5 hp Johnson Outboard

    does it work ? try running it with a good cleaner like Merc Power tune or Evinrude engine cleaner. some folks like Seafoam some don't tried a different pressure meter seems the short ones are better compared to the long hose attached meters
  7. C

    New points not gapping, 1957 Johnson 35hp Javelin

    any side by side pics ??
  8. C

    200HP FICHT oil issue I'm STUMPED!!!

    check your PM,s
  9. C

    Loss of power in 1988 Evinrude 88 spl

    sell parts...:-(
  10. C

    200HP FICHT oil issue I'm STUMPED!!!

    the folks on the ETEC board concentrate on ETEC only but.. maybe you can ask if there are any former...FICHT experts to help out .
  11. C

    200HP FICHT oil issue I'm STUMPED!!!

    no expert on ficht but I suffered years of "start up" code 38 NO OIL on my 75 ETEC (2005) all fixed up by a BRP upgrade on the pump and sotfware load . if you visit the ETEC owners board and search CODE 38 tons of info...
  12. C

    New points not gapping, 1957 Johnson 35hp Javelin

    let us know if the new ones work out and how the characteristics differed
  13. C

    Did I cause damage?

    looks like just carbon wash out from flooding fuel coming out the cavity drain hole. if it works don't fix anything
  14. C

    New points not gapping, 1957 Johnson 35hp Javelin

    compare old points rub arm length with the new points not certain but I seem to recall some points have short rub arm ans some are longer make certain you have the proper part # for your engine model
  15. C

    59’ Evinrude 5.5hp single fuel line conversion

    try 1 L oil tcw3 for 25 L of gas
  16. C

    59’ Evinrude 5.5hp single fuel line conversion

    nothing special ... pump it up choke it it start it adjust the the carb enjoy
  17. C

    78 Evinrude 9.9

    much like the 9.5hp it is just a mechanical stop has describded by optsy. fine tune the needle ... lower the speed to just about shut-off turn the knob to stop any further travel which would stop the motor. kill it with the stop button
  18. C

    1964 big twin electrical gremlin

    see pic if similar to your more modern engine
  19. C

    1964 big twin electrical gremlin

    strangely this set up worked for years ??? is the green on the red BAT + wire on the Regulator the same as the green on the Bat - ground post if I dare ask..:-( if it is may as well take it off and retry a new fuse. ) some drawings show the BAT+ out of the reg just going to a...
  20. C

    1964 big twin electrical gremlin

    well... E=R x I E/I=R so 12v/10amps = value R value of 1.2 ohms or...less to blow that fuse start ohming out the load on the 12 volt distribution side of the blown fuse measuring with Bat. ground if equal or less than 1.2 ohms begin disconnecting loads along the...
Top