Search results

  1. alldodge

    4.3 mercruiser alpha 1

    AF in the oil pan, well that's not good
  2. alldodge

    4.3 mercruiser alpha 1

    There is rust on the bottom of the plugs, and a bit on a couple of the tips. The rigs are probably rusted to the cylinder walls Spray more oil in the cylinders and let it sit for couple days
  3. alldodge

    4.3 MPI Runs rough after putting in gear

    Has the fuel filter been changed? Have you checked fuel pressure?
  4. alldodge

    2015 Motor MerCruiser 4.5L 250hp NO EC - OVERHEATING!

    Welcome It looks like your on the right track to stop the overheating
  5. alldodge

    Does anyone know this part #??

    Maybe another knows where the parts breakdown for the Yam controls, but I would find a NAPA store and show them what your looking for, they should have it. Now if you have a vernier caliper, just measure it and buy online
  6. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    No Very, very rare for a coil to go bad. Folks replace them all the time, wish I had stock in the coil Co I'd be rich
  7. alldodge

    Mercruiser Alpha 1 Gen II leaking above speedo hose

    It's in the exhaust so no issue with water coming out Have fun and go boating
  8. alldodge

    rpm signal wire and est ignition

    This should help, it's a 3.0 but wiring is the same, note the Gray wire
  9. alldodge

    5.7 GXi-HF pressure in power steering reservoir

    Don't see that as a issue. Prior reservoir caps had loose seal full vented, even had a rubber disk under the cap to keep the splashing away from cap. New caps seal much tighter, so when oil heats up so does the pressure. If cap removed when hot, then when it cools back down then there would...
  10. alldodge

    What is this

    Welcome Looks like a capacitor, remove the tape and see if there is any writing on it
  11. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    While your at it check fuel pressure, it should be 43 psi
  12. alldodge

    89 Mercruiser 3.0 stalls at 2000rpm

    Welcome Is this a new to you boat? How long has it been doing this? Most likely the carb needs rebuilt, the accelerator pump may not be working correctly.
  13. alldodge

    Gimball ???

    I would think it's the U joints
  14. alldodge

    Crank Shaft Position sensor seating Indmar/Chevy Vortec 350

    GM sensor is good
  15. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    If your gauge is accurate then the motor is tired, should be closer to 150. Check the timing as seen in the pic. Bring number 1 to TDC and then verify distributor location
  16. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    What does good mean? Agree, how old
  17. alldodge

    Knocking sound - what is it? [video]

    Sounds like an exhaust leak
  18. alldodge

    Crank Shaft Position sensor seating Indmar/Chevy Vortec 350

    Might not be the sensor, might be bad connection, moving it causes it to make connection again
  19. alldodge

    throttle body discontinued

    We're a DYI place, so we really need to see real numbers We all do the quick response (me mostly) you need to do this, kind of thing Shop A saying all was good means nothing when shop B says a couple paint chips leads to paint removal, new injectors and still have same issue(s) So your out a...
  20. alldodge

    2008 Chaparral 275 SSI 8.1 Volvo Penta GXI-J Soft Alarm Issues

    That's a great pic Ted, I'm going to steel it , just FYI :ROFLMAO:
Top