Search results

  1. alldodge

    2001 Johnson 70

    How's the compression?
  2. alldodge

    1993 5.0 EFI Fuel Issue/ Hard starting

    Don't make multiple threads in different areas, they have been merged
  3. alldodge

    Changing my boat gauges.

    All gauges should have full Bat voltage, only the sender wires would have less. If ground is bad (probably is) then taking a reading will be off. Use a jumper wire from Neg Bat terminal to the meter and then take readings.
  4. alldodge

    2010 350 Mag MPI bravo 3 gaurdian mode issue. 5% power

    No officer I didn't steel it, no one saw me do it I'm sure
  5. alldodge

    shift issue and running with some noise from lower unit gear

    Should never start or run that high, that was the U joints banging around
  6. alldodge

    shift issue and running with some noise from lower unit gear

    Your drive is to high, does it reduce when it's lower?
  7. alldodge

    VP SX 3868584

    Call any VP dealer or searching for the part number online and it comes up. Looks like over 10K
  8. alldodge

    shift issue and running with some noise from lower unit gear

    Your not going into throttle only. Try this, move shift to neutral, grab the bottom of the shifter and pull out. It should move out toward you, then move handle forward
  9. alldodge

    shift issue and running with some noise from lower unit gear

    4 buttons? I see 1 switch with 2 buttons If the handle button does move in and it's not disengaging the shifter, then it needs repaired or replaced
  10. alldodge

    a carburetor shouldn't spill fuel like this, right?

    Don't know which V6 other then one with a 4 bbl Find the original fuel pump was 805656A5, is this the pump your have? Put a couple gal of old stuff in a full tank and the truck should not have much issue, or run it in the lawn mower, but even the mower can have issues
  11. alldodge

    shift issue and running with some noise from lower unit gear

    I don't see a throttle only button on your shifter. Yours should be pulled out in neutral then moved forward for throttle only
  12. alldodge

    5.0 MPI Misfire Under Load

    What's your serial number?
  13. alldodge

    1987 OMC 2.3l Bluefin 1900 Sportsman wiring

    Other then standard wiring practices we're probably not going to find anything to help. I would suggest as you thought of and just replace the fuse panel with something like the Blue Sea model
  14. alldodge

    Changing my boat gauges.

    Not necessarily, might just be a bad Tach, but bad Tach can cause ignition problems
  15. alldodge

    Marinepower Vortec 4.3 White/Red wire jumped together

    With a inboard there will be a switch on the trans mission. If used on a I/O then leave as is and go from key start pin thru shifter then to slave relay Also moved thread
  16. alldodge

    Marinepower Vortec 4.3 White/Red wire jumped together

    Looks more Yel/Red to me, and if so could go to neutral safety which is bypassed
  17. alldodge

    Boat won’t shut off

    Yes but your battery is not being charged
  18. alldodge

    Water heater to engine. Previous owner cut and removed water heater hoses at stringer. See photos, where should they connect at engine?

    Check the water heat to be sure it doesn't have an issue. Looks like it may have been plugged up and maybe because of an issue. Port on Stat housing is plugged and the bottom hose may have had a Tee in it.
  19. alldodge

    Water inlet hose replacement on Bravo 3

    I used the new style hose doing mine https://forums.iboats.com/threads/bravo-itis-fix.680176/
  20. alldodge

    please help timing issue is the expected issue help!

    GSI could be PBYDCE MEFI-1 PWTR MEFI-3 EST ignition To set timing place a jumper across the DLC connector at pins A and B to put motor in base timing mode. Then adjust timing
Top