Search results

  1. alldodge

    Merc 60 EFI Fluctuating motor speed at any speed, air in fuel filter

    Welcome Folks need the most info possible to help and motor serial numbers are best
  2. alldodge

    Bravo 3 Shifting Issue

    Here is the latch
  3. alldodge

    My boat is being a boat . . .

    Just guessing, but probably burning more fuel with the tabs down a bit even with turning less rpm's Could use the slip calculator to see, and what does VV show?
  4. alldodge

    1994 Astro S-18FS (won't start)

    For S/N 0G101962 Service manual is 90-8M0127990 Parts manual 1779394 Motor parts break down along with support material https://www.mercruiserparts.com/115-4-cyl--0d283222-thru-0g760299
  5. alldodge

    CMC tilt and trim

    Welcome I think CMC is a jack plate of some kind and it's not working. If correct please advise Get a voltmeter and start checking from the Battery to the switches, might be a bad connection or blown fuse or breaker
  6. alldodge

    1993 Evinrude 150 no spark

    Welcome Don't start a new thread because someone has not responded, sometime it takes a while for folks to notice. Hang in there someone should come along. Can also repost question to the same thread to get it back on top
  7. alldodge

    Random no crank on 5.0

    Moving the Bat switch should have no effect on starting unless there is a bad connection, but a bad connection normally causes the starter to click or something else. Might be the key switch, neutral safety switch, slave relay or bad connection between key and starter solenoid
  8. alldodge

    8.1Gi milky oil and making oil

    It's not the oil cooler. The oil pressure is higher then the water pressure, and if cooler had a crack the oil would be leaking out and into the water. Oil level would drop I would think head gasket. Pull the plugs and see which one(s) look steamed cleaned
  9. alldodge

    1994 Astro S-18FS (won't start)

    No that's the neutral safety switch and it's not your problem Sounds like you may not have a kill switch. The kill switch gets a tether (lanyard) attached to it and other end is attached to the driver. If the drive falls overboard it pulls cord and kills the motor
  10. alldodge

    1994 Astro S-18FS (won't start)

    The tether is the kill switch or man overboard kill switch
  11. alldodge

    Bravo 3 Shifting Issue

    Howdy and welcome aboard The bravo is not done like a Alpha. Alpha's have to be put in foward when installed, bravo is removed and installed in neutral. There is also a latch on the drive side that is latched in place on the shift cable just before the drive fully makes contact with bell housing
  12. alldodge

    Mercruiser connector confusion

    Post pics of your plugs, helm and engine Where do the two 10ga hots go to?
  13. alldodge

    1994 Astro S-18FS (won't start)

    I moved it, this is why it's here, you had it in the Astro boat section
  14. alldodge

    1987 OMC 2.3l Bluefin 1900 Sportsman wiring

    This is what I found, and could also check on forum "The Hull Truth", those guys are mostly offshore boaters https://www.bluefinboats.com.au/contact-us
  15. alldodge

    Engine Alignment tool goes in about 1/4 of the way, question.

  16. alldodge

    1987 OMC 2.3l Bluefin 1900 Sportsman wiring

    Being a Blue Fin there may be a wiring diagram but finding it will be the issue. Have you tried to contact Blue Fin in Australia?
  17. alldodge

    1994 Astro S-18FS (won't start)

    Welcome aboard Moved your thread to Merc OB's so it will get more views
  18. alldodge

    Location of fuse box on OX 66

    You mentioned Bondo said So were talking about maybe a breaker without a reset part so "auto-reset breaker" came into the discussion
  19. alldodge

    Location of fuse box on OX 66

    Sir, let's simmer down and not lash out from what you think is being said
  20. alldodge

    Dean's List gets another motor

    Brand new never been used crank, don't know what a flap wherl should be able to do
Top