Search results

  1. alldodge

    Volvo Penta 5.7 no spark

    Have to apologies in advance. I noticed his add showed it came with 94029 and 94032 which are the adapters I need for my newly bought motors. So I bought one and he just sold the other. Hope you got the first one if you wanted it
  2. alldodge

    Parts availiability ??

    I looked at NGK and they show the plug as discontinued Looked it up on crossreference and shows NGK 5626 Comparing the 2 on NGK site look the same to me, same heat rage and everything
  3. alldodge

    Volvo Penta 5.7 no spark

    Found this on OSO, has 2 Techmates with 94029 https://www.mercruiserparts.com/496-mag-base-model-0m025000-thru-0m6
  4. alldodge

    Volvo Penta 5.7 no spark

    There is probably nothing wrong with the fuel system, but we don't know for sure. The fuel pump turns ON for couple seconds prior to cranking. The initial ON should still build to operating pressure. The low side pump will bleed off kind of fast but the high side should not Diacom cannot...
  5. alldodge

    Volvo Penta 5.7 no spark

    That's called a Schrader valve There is one on the pump which is the low side and another on the fuel rail where the injectors are attached. If you had a fuel pressure tester (can be found at local auto parts stores) you could test the pressure Low side 4 to 12 psi ( 27 to 82 Kpa ) High side...
  6. alldodge

    Volvo Penta 5.7 no spark

    Low side on pump should be 8 or so psi so it should spray out High side on the fuel rail should be 50 to 60 psi so it should really spray out
  7. alldodge

    350 mag MPI will not turn up past 3500rpm

    Do you have a in gear switch on the shift plate? If so, unplug and try it
  8. alldodge

    350 mag MPI will not turn up past 3500rpm

    Sorry about that my bad will change my post above. Got mixed up and forgot where I was
  9. alldodge

    Volvo Penta sea water pump

    It probably uses the Johnson F6B-9 pump but @Scott Danforth or @kenny nunez should know for sure https://www.amazon.com/RELIABLE-PARTS-SYSTEMS-Impeller-Engines/dp/B01BO3AY9I/ref=psdc_15725491_t1_B00K8EP10C
  10. alldodge

    350 mag MPI will not turn up past 3500rpm

    From previous thread this is twin motors (for anyone looking) My mistake Many auto parts places will loan a hand held Tach. If it backs up the boat Tach then its something else and scanner is needed. With both doing the same it may be Rev limiter, knock sensor picking up detonation, sync if...
  11. alldodge

    4.3 mercruiser overrev alarm

    Disconnect it
  12. alldodge

    Building A Mercruiser 350 Few Questions.

    Meaning it needs to be in the water for break in, a hose can not supply that amount
  13. alldodge

    Building A Mercruiser 350 Few Questions.

    Not sure, lets see what @Scott Danforth thinks
  14. alldodge

    Building A Mercruiser 350 Few Questions.

    The flat tray is bolted to the mains, so you would also need mains with a stud. Pic in this thread shows similar one installed Don't need both, https://www.corvetteforum.com/forums/c4-tech-performance/2845237-windage-tray-oil-baffle-bolt-locations.html#&gid=1&pid=1
  15. alldodge

    1975 35 Double Alternator

    Are you sure it's 80ish, it could be a defective gauge? To verify remove sender and install a handheld mechanical gauge. If it is that high and the motor has not been modified (rebuilt with high volume oil pump) then it could be the pump bypass valve is stuck, filter or remote filter. Does the...
  16. alldodge

    Maybe my turn for new boat time

    After getting the boat home we noticed there was a small gouge up by the anchor. Figured anchor hit the boat when dealer was installing it. Then there are a rub spot on each side of the stern. Looks like this is where the strap might have been to hold during transport Sent email to Dealer...
  17. alldodge

    Maybe my turn for new boat time

    More Fun :rolleyes: Dealer has to order Gel so not going to get it back this week Verado manual states to use AGM Bat at least 800 MCA, Chap installed Lead Acid. So they saved what, 200, gee wiz
  18. alldodge

    api scan tool opinions?

    Only goes up to 2017 that would be a problem
  19. alldodge

    api scan tool opinions?

    Member @tpenfield has diacom, don't know anyone with API
  20. alldodge

    Volvo Penta 5.7 no spark

    It looks to me like your motor has both connectors image 1079 for connector 94029 CAN and image 1082 for connector 94024 EGC. The 94029 is the newest connector, if it was me I would go with it 94024 - $59.00 94029 - $249.00 Diacom - $599.00 Techmate - $499.00 Kit 94030c - $719.00 Diacom with...
Top