Search results

  1. alldodge

    Stalling and Starting problems

    Have you looked down the throat of the carb when its stalling to see if its flooding? If not flooding pump the throttle to see if fuel is squirting Choke full open?
  2. alldodge

    Stalling and Starting problems

    Need more info about the motor, have a serial number? Being a 98 I'm thinking it might be a TKS carb
  3. alldodge

    Adding a Temperature Gauge

    With the resistance readings shown you must be on the other side of the pond. North American standard is 240 cold , 33 hot
  4. alldodge

    Maybe my turn for new boat time

    Got it back today and took it into town to fill up. It took 113 gal and then went home and put it back in the barn Have not looked at the Bats yet, but was told they would be switched to AGM
  5. alldodge

    Parts availiability ??

    It's the Ford Chevy thing
  6. alldodge

    MerCruiser throttle cable

    No, but you need to first know how long, then look for that length then look for Merc
  7. alldodge

    NMEA adapter to connect Garmin chart plotter and iCom radio?

    Maybe, the converter is 200, a plug n play 2000 is over 300 and most 400 Been looking my self for my new boat, be nice if they had a regular size flush mount with 2000. All the ones that have it built in are larger units
  8. alldodge

    NMEA adapter to connect Garmin chart plotter and iCom radio?

    Need a NMEA 183 to NMEA 2000 converter https://www.pysystems.ca/resources/hotwire/nautical-networking-nmea-0183-and-nmea-2000/
  9. alldodge

    MerCruiser throttle cable

    Throttle cable is based on length. Determine how long yours is then search for same
  10. alldodge

    Another Plumbing Question

    Not here, City water and Pex from meter to house My house has copper from meter in to house and all copper pipes. Have regular metal electric water heater with diaelectric unions on in and out and very little corrosion but there is a trace after 4 years so far.
  11. alldodge

    Another Plumbing Question

    Good thought, have looked quite a bit on the electrical side. Main panel is done correctly from what I've seen, disconnect is good House built in 2007 and all water lines are Pex except where lines come out of the wall. Being there is no ground except from power feed, it sure looks to be from...
  12. alldodge

    Replacement ignition coil

    Take with grain of salt, but new 9.9 appears to use same coil but has different connectors 803559A02 It is $112 https://www.mercruiserparts.com/803559a02-ignition-coil
  13. alldodge

    Electronic issue, no power pole, gps or radio power

    Check fuses and Battery switch. My guess is there is a bad connection. Might remove and clean up all the cable ends You should not use BOTH unless you need it to start the motor. Leave it on Start Bat (probably 1) and use the Bat charger to charge Bat 2 when you get back home. If your motor...
  14. alldodge

    Another Plumbing Question

    Don't know but the tank is about 2 years old, and it is a bladder tank so no metal in it. I changed it out to all brass so I'll keep a watch on it
  15. alldodge

    Mercruiser 4.3 Temp Alarm Question

    The Tan/Blue is on the Temp switch that is on one side of the thermostat housing. The Temp gauges sender is on the other side of the housing.
  16. alldodge

    Alpha One Gen II shift shaft seals

    Good point the B3 has oil on one side and water on the other.
  17. alldodge

    Mercruiser 4.3 Temp Alarm Question

    Yes TKS No mention of the motor stumbling when alarm is heard so it should not have anything to do with TBV module (knock, over speed, over Temp) Think this is either the lube bottle float sticking or a chafe on the Tan/Blue wire. The TKS takes the over Temp switch and sends it through the TBV
  18. alldodge

    Alpha One Gen II shift shaft seals

    I agree with your assumption, the lip should be toward the water so it will have a better chance of sealing Similar issue with seals and the B3 prop shaft. Early (manual 11) has 2 seals and states to place seals in facing each other. First (inner) lip faces out and Second (outer) faces in...
  19. alldodge

    Mercruiser 4.3 Temp Alarm Question

    Pull one of the leads off the lube bottle and see if it does it again. If it does reconnect bottle Have IR Temp gun and when it beeps measure thermostat housing. If its good, disconnect Temp sensor (the one with 2 wires) BTW does motor have a TKS carb?
  20. alldodge

    Gimbal Bearing Cheap

    You can't pull and not damage the bearing because the puller applies all forces to the inner race. The installer applies forces to outer race It's not going to just go out. Just use it
Top