Search results

  1. alldodge

    VP 5.7 Gi-J three or 4 sparks only

    Good deal, one of Muc guiding principles, don't replace parts till you know something "is" bad
  2. alldodge

    EST1 Open

    The analog gouges are simple enough, need 12 to 14 V, ground and sender providing variable ground. Your reading low so resistance is high or bad connection. Check your connections, voltage and with power OFF measure resistance of sender to helm ground at the gauge
  3. alldodge

    Electric panel toilet switch

    Good point Q, might be for the mercerator, but I think that should keep running until turned of, right?
  4. alldodge

    Dean's List gets another motor

    It's going in a 37ft cruiser, closed cool
  5. alldodge

    Dean's List gets another motor

    Did it yesterday after she left for her sister's in IN. No T day here and will meet her Saturday for T day
  6. alldodge

    Dean's List gets another motor

    It's 60 over and ring gap is in spec. Had to bore one cylinder over 60 and install sleeve. Crank, rods, pistons installed
  7. alldodge

    SWITCH ASSEMBLY, CUT-OUT-TRANSOM PLATE

    Should have posted this in the Merc section because its a motor topic. The switch will be normally open and close contacts when shifting into neutral. Without the switch as you have found its hard to shift out of gear What I said above is only true if the ignition is original, meaning has not...
  8. alldodge

    Electric panel toilet switch

    Well..... normally there is a water pump switch and its just left ON and the pump cycles each time water is needed. Having one mark as toilet maybe done the same way. That said I wouldn't leave either ON when you leave the boat
  9. alldodge

    Darn Mice Can Be Expensive

    Have a bucket trap in the barn and caught a few. Been putting PB in the center and as they walk out the roller turns and they fall in. Now the sort of funny part. Found the PB gone on all they way around and no mouse. Put more on it and next day all gone and no mouse. Set trail cam up and...
  10. alldodge

    2013 F250 6.7 Powerstroke

    Way cool
  11. alldodge

    EST1 Open

    Sender checks out for 240 (cold) to 33 (hot) ohms Put sender in pan a water with thermometer and ohm meter connected to see how it changes as water heats up
  12. alldodge

    EST1 Open

    Good deal What's the part number of the sender?
  13. alldodge

    Reattach cap to hull

    ...
  14. alldodge

    Reattach cap to hull

    It's very doubtful the top cap will ever need to be removed again, but if it did it would be better with silicone
  15. alldodge

    Mercruiser 6.2 Fuel System Fault Code

    Don't think there is. Some time back I found a draft copy of the PCM 112 codes. Being draft it was just a start. Search for PCM 112 codes and you may find it still out there
  16. alldodge

    Mercruiser 6.2 Fuel System Fault Code

    902 The PCM has had to add too much fuel trying to get the correct O2 reading. The 902 code should clear when the O2 sensor is fixed
  17. alldodge

    Trolling motor powered by DeWalt 20 volt battery is rs

    Yes as Scott mention, use a hammer, a Big F Hammer and the shock usually breaks it loose
  18. alldodge

    2004 Glastron GS 249 Propeller - Need Informationx

    A Merc prop can be used on a VP "IF" the hub is changed https://www.ebay.com/itm/140900264192
  19. alldodge

    Deadman Switch?

    More of the higher end manufactures have been installing a windless, even on big bow riders. My 27ft has one The small OB ground the magneto to kill the motor, remove ground to start.
  20. alldodge

    Trolling motor powered by DeWalt 20 volt battery is rs

    Should be no issue so long as motor is 24V
Top