Search results

  1. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    All sensors work off a single 5V reference produced by the ECM. Any sensor that draws to much current causes all kinds of issues
  2. alldodge

    2005 bayliner 4.3

    Could fire up the motor with module unplugged and if it stays cool then its the module
  3. alldodge

    2005 bayliner 4.3

    Thats a diode. It may ok but something is drawing to much current. If it cools down after the module is unplugged then its just the module. If it remains hot then might be the temp switch
  4. alldodge

    1997 Glastron 24GS alsrm

    Start the motor, then disconnect one by one the lube bottle, temp switch and oil pressure switch. Temp switch is on thermostat housing has 2 wires on it, gauge has one. Oil pressure switch is low port side next to oil pressure gauge sender. The oil switch is the smaller of the 2
  5. alldodge

    Exhaust bellows

    No it won't sink. On Bravo 3 they only do Tubes instead of bellows
  6. alldodge

    Intermittent Spark

    Sounds like a good idea.
  7. alldodge

    2003 Merc 5.0 MPI no start, intermittent spark

    How about your kill switch? Check for 12V at the coil with key ON and see if it stays there when cranking
  8. alldodge

    Exhaust bellows

    No its not needed. They make a exhaust tube which just connects on the transom side
  9. alldodge

    Electrical Issues after replacing trim switch/sensor 7.4 EFI/MPI

    Don't see a stuck key melting the fuse, but it would cause some issues. The beep garble might just be the beeper having an issue, don't know for sure. The blower might be the wasp or just bad connections, have to look
  10. alldodge

    2005 bayliner 4.3

    Would like to see the red terminal that is getting hot There has been several times where the Temp switch started shorting out. Your not blowing the fuse but something is drawing enough current to drop the voltage is my guess
  11. alldodge

    Engine wont shut off with key

    This is the real answer. With Pertronix the wire from the I terminal to the coil is no longer needed. Don't know all the wiring changes, but I would guess there isn't a resistor wire from the key, its just a wire. Remove wire off I and the coil There is still an issue with power going to the...
  12. alldodge

    2005 bayliner 4.3

    Just thought of something else. Originally Merc put 20 amp fuses in ignition, if you have a 15 amp, replace with 20. If it does good, its probably still the module
  13. alldodge

    5.7 torque specs

    I thought you were going to post to your other thread I was PM'ed eariler asking for this info and said it needs to be on the forum
  14. alldodge

    2005 bayliner 4.3

    Thanks TKS carb, I'm thinking its the module right now Get it running and warmed up if it will last that long, then disconnect the TKS carb module and see if it does ok
  15. alldodge

    Vovlvo penta Alternator, starter and fuel pump questions

    Not Motorola its prestolite Yes, red/Pur and Pur are connected together Clean the terminals up and see what the readings are
  16. alldodge

    Engine wont shut off with key

    Remove it please and see if the problem still exist Please don't change stuff and then ask questions to same problem What is the old wire that probably went to starter, and the new wire? In old pic there was 2 red wires on the right side and now there is one?
  17. alldodge

    Vovlvo penta Alternator, starter and fuel pump questions

    Red/purple and purple should not be connected together Reading 12.5v on the purple is most likely from bad connections, it should read full V of the ALT If your motor is wired like the drawing above (less keep Green and purple together) it should run as designed Mando ALT wiring J is purple...
  18. alldodge

    2005 bayliner 4.3

    Thank you What is the motor serial number, or at least is it efi or mpi. If its carb does it have TKS? Something is heating up and drawing more current. If its TKS might be module
  19. alldodge

    Engine wont shut off with key

    The voltage is jumping around because you have points Explaine the differences in the 2 pics
Top